SOURCE: need to change oil pan
e
Cavalier, Sunfire 2001-2005
Oil Pan - Removal & Installation
2.2L (VIN 4) Engine
To install:
Negative battery cable
Right front wheel
Right inner fender splash shield
Starter motor and bracket
Engine mount strut bracket
Oil pan
Fig. Exploded view of the oil pan mounting and related components-2.2L (VIN 4) engine
2.2L (VIN F) Engine
Oil pan with a new gasket. Torque the nuts and bolts to 89 inch lbs. (10 Nm).
Engine mount strut bracket. Torque the bolts to 49 ft. lbs. (66 Nm).
Starter motor and bracket. Torque the bolts to 37 ft. lbs. (50 Nm).
Right fender splash shield
Right front wheel. Torque the nuts to 100 ft. lbs. (140 Nm).
Negative battery cable
To install:
Engine mount strut bracket
Drive belt
Lower then upper AC compressor bolts
Oil pan bolts
Oil pan
Fig. Remove/Install the oil pan bolts in this sequence-2.2L (VIN F) engine
Oil pan and tighten the bolts to 18 ft. lbs. (25 Nm)
AC compressor bolts
Engine mount bracket
Drive belt
2.4L Engine
To install:
Negative battery cable
Flywheel/converter cover
Right wheel
Right wheel well splash shield
Accessory drive belt
Air conditioning compressor lower bolts
Transmission-to-engine brace
Engine mount strut bracket
Radiator outlet pipe bolts
Radiator outlet pipe from the oil pan
Oil pan to the flywheel cover bolt and nut
Flywheel cover stud for clearance
Radiator outlet pipe from the lower radiator hose and oil pan
Oil level sensor connector
Oil pan
Oil pan with the gasket. Torque the M8 bolts to 18 ft. lbs. (24 Nm) and the M6 bolts to 106 inch lbs. (12 Nm).
Fig. Oil pan fastener torque specifications-2.4L engine
Oil pan to the transmission nut
Oil level sensor connector
Radiator outlet pipe to the lower radiator hose and oil pan
Exhaust manifold brace
Radiator outlet pipe. Torque the bolts to 124 inch lbs. (14 Nm).
Engine mount strut bracket. Torque the bolts to 55 ft. lbs. (75 Nm).
Transmission to the engine brace
Air conditioning compressor lower bolts. Torque the bolts to 37 ft. lbs. (50 Nm).
Accessory drive belt
Right splash shield
Right front wheel
Flywheel/converter cover
Negative battery cable
Hope helped (remember rated this help). Good luck.
SOURCE: Hi, I have a 2006 chevy aveo and I was recently
Its easy. I did mine about a month ago. You need to take off all the bolts on the top part of the motor. there are some tubes on the left side of the motor by pushing them out of the way... you take the old one off and replace it with the new one making sure its aligned and the you put it back on.. the bolts need to be hand tightened kinda as tight as you would do your tires.
SOURCE: What is causes my chevy aveo to leak oil?
is the valve cover leaking? Is the cover bent? Did you use a new gasket? Where specificaly is it leaking from?
The manual transmission does have an oil pan. Try tightening the pan bolts to see if any have come loose causing the leak
934 views
Usually answered in minutes!
×