Possible adjustment of linkage to hydraulic cylinder for clutch
SOURCE: suzuki grand vitara 2.0 TDI
This could the problem with onboard computer failure .......
try that after visual check under hood confirms no obvious failures like missing drive belt or disconnected electric wires...
Please mention make code and year of the peugeot engine in the car.....
Good luck....
SOURCE: where is the starter for a 2000 suzuki grand vitara located
starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch
SOURCE: have to change clutch plate on suzuki grand vitara
If it's hard to get into gear you should check the clutch is disengaging properly.
Before changing the clutch plate, check that the clutch throw-out is adjusted correctly and the actuating hydraulics/levers have the correct amount of travel.
SOURCE: problems with clutch master cylinder on a suzuki
I too am having problems with my 2006 GV clutch master cylinder. I noticed gradually over several weeks the gears and clutch pedal were degenerating and then the cluth gave completely. My mechanic took a look around and said the cylinder is the cheapest one he has ever seen, it's just a piece of plastic apparently! Is going to hopefully get the part this week or next, though he said as it's such a cheap and nasty part its likely it will happen again in the future. Not happy!
Clutch
ADJUSTMENTS
1997-98 Models
CLUTCH PEDAL HEIGHT
The clutch pedal height should not be a periodic adjustment but may be checked after components of the mechanical clutch system have been replaced.
The proper clutch pedal height should be 0.2 in. (5mm) above the brake pedal height
If adjustment is necessary, loosen the locknut and turn the adjusting bolt until the appropriate height is reached. Once set, keep the bolt from turning and tighten the locknut to secure the adjustment.
CLUTCH PEDAL FREE-PLAY
The clutch pedal free-play should be checked from time-to-time in order to assure proper clutch operation.
The proper clutch free-play should be 0.6-1.1 in. (15-25mm).
Fig. 1: Pedal free-play is adjusted at the joint nut (2), while keeping the outer cable nuts (3) tightened around the center cable thread portion
259 views
Usually answered in minutes!
×