SOURCE: 98 chevy s10 blazer turn signal
Unplug the turn signal relay from the fuse box and start you engine. Does it still make that noise?
If yes... Put the relay back in, that is not the problem.
If No...Then the relay could be bad, replace it!
PLEASE RATE THIS SOLUTION! Thank You Very Much!
SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks
have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.
SOURCE: How do you replace the brake lines for a 1996 Chevy S10 Blazer
You have the best diagram right on your car! follow the original lines to replace them. (you can change routing a little with no problems, just make sure they dont interfere with anything and that they are secure so they don't rub through and fail again!
SOURCE: 1989 Chevy S10 Blazer, 4.3L V6. 4wd not working.
under the battery is where you need to check first,then follow it down around the right front wheel well,
657 views
Usually answered in minutes!
×