2005 Ford Freestar PATS assembly...should a replacement work just being plugged in but not installed in the column? Does the tumbler not installed make a difference?

SOURCE: where is the low tire reset button located on 2005 ford freestar?

It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.

SOURCE: i cant get my truck to start because of the anti-theft lock.

Pull a spark plug wire and check for spark.

SOURCE: R&R Steering Wheel Assembly and/or Steering Column Assembly

if you disconnect the battery and let it sit awhile this will disable the airbag.

Jun Magno

• 175 Answers
• Posted on Jun 02, 2009

SOURCE: anti theft device for 1997 ford expedition

try using a spare key first

SOURCE: Need to replace headlight assembly on 2005 Ford Escape

ithere are 4 bolts that hold it in...the top 2 are obvious..the others are behind the bumper. the bumper must be removed to acces them...here are the manuals instructions..


Item Part Number Description 1 — Headlamp assembly bolts (3 required) 2 — Headlamp assembly nut 3 13008 Headlamp assembly 4 14290 Electrical connectors
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. Remove the front bumper cover. For additional information, refer to Section 501-19.

1. Remove the 3 headlamp assembly bolts.
   • To install, tighten to 5 Nm (44 lb-in).

1. Remove the headlamp assembly nut and the headlamp assembly.
   • Disconnect the electrical connectors.
   • To install, tighten to 5 Nm (44 lb-in).

1. To install, reverse the removal procedure.