Drivers side of motor on block behind the altanater
SOURCE: 1997 Dodge caravan crank position sensor
it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.
SOURCE: 2006 Dodge Grand Caravan - EGR code
I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.
SOURCE: Cam Shaft Sensor Problems
Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.
SOURCE: knock sensor dont work for 2005 dodge durango
this problem is very seldom the knock sensor, it can be the harness connector at the sensor or the engine has excessive knock which will set a code, u did not mention the particular code so hard to say, the location of the knock sensor is the lower section of the engine block, it is screwed into what would normally be a block drain plug, if u replace it u need to torque it to whatever the factory spec is or it can cause it throw another code..
SOURCE: location of oxygen sensors on 2002 dodge grand
The o2 sensors are located on the exhaust system.The upstream in on the rear exhaust manifold and the down stream is in front of the catalytic converter.Usually when they are bad they will make the check engine like go on.Make sure the air filter is clean,tires at correct inflation,alignment is to specs.If the vehicles pulls to one side or the other or steering wheel is not straight when driving down a straight stretch of road.Also tires are wearing normal.Use cruise control where ever on highway.If you let your vehicle warm up in winter.This also uses gas.Hope this helps.Good luck.
2,776 views
Usually answered in minutes!
×