Ya just get a help manual for repair. simple! I have repaired a lot of cars mine and my frnds cars and bikes using free manuals only.. u will find it on www.reliable-store.com
Just try to get one asap
The year is needed and you need the original code to
Which year?
SOURCE: reprogram keyless entry system
1991-94 Nissan Maxima key less entry reprogramming procedure:
1. Enter the *original code found under the dashboard.
(*the code begins with the letter F and has 7 digits)
2. Close the doors and lock all of the doors,
enter the 7 digit code
( make sure you have your key in hand).
3. Once the code is entered correctly you will hear a long beep ♪ ♫.
While the beep ♪ ♫ is sounding ... ENTER your NEW 4 digit code, (you will then hear random beeps ♪ ♫)
Do not touch anything until the beeping ♪ ♫ stops.
4. To open the doors, the front windows and the
trunk,
type: S(Clear) and the New 4 digit code and the door will
open automatically.
5. IF by any chance you forget your new code. Just enter the original one and start all over.
SOURCE: keyless entry code
They normally stamp the Keyless entry code in the trunk and if not I belive the Computer that controls this is located behind the Glove box and they normally have the code printed on it.
SOURCE: how to reset factory code on keyless entry ford five hundred
if you do not already know the factory code, the only way it can be obtained is by your local ford dealer. the proprietary computer equiptment they have can access the code that is programed in vehicles security module. if you purchased it used..it is often that the keyless entry code id card is still withe the owners manual..it is a 5 digit code printed on an credit card sized card that is white in color..i hope this helps you...good luck
SOURCE: factory keyless entry pad code where is it please.
You can take your registration and driver license to a dealer and they can use their diagnostic tool to retrieve it from the computer. It should cost 1/2 hour of labor. Call first & ask.
Also, look in glove box for a plastic "credit card" with the code on it.
SOURCE: need to change the factory keyless entry code OR the module
Programming your own personal entry code
To program your own code:
5. Enter factory set code (keypad will illuminate when pressed).
6. Press 1/2 control within five seconds of step 1.
7. Enter your personal 5 digit code.
Enter each digit within five seconds
of previous one.
8. After the code is entered, the
locks will cycle, confirming that the
new code has been set.
Do not set a code that includes five of the same number or presents
them in sequential order. Thieves can easily figure out these types of
codes.
Keep in mind, if the battery is ever replaced or goes dead, the keycode will revert back to the factory setting.
77 views
Usually answered in minutes!
×