Need tutorial on replacing the rear wheel bearings in my 2008 Ford truck 4x4. I found info on the front, but it's the back I need help with.
Replacing bearing involves removing axle your not replacing a hub but tearing apart axle 99 04 F250 Sterling Rear axle bearing replacement Pt 2 2006 Ford F250 rear hub axle seal replacement F250 Rear Brakes Axle Hub Removal Install 03 07 Powerstroke
SOURCE: front wheel bearing removal on 2006 F350 touchtone 4X4
Get a good repair manual. Front ends on 4X4s require proper care.
SOURCE: replace rear wheel bearing 2002 ford explorer 4x4
you must remove brakes, then remove axle nut, then remove upper control arm and finally tie rod stabilizer, remove axle from car then bearing can be accessed. this is a difficult job that requires special tools so be careful
SOURCE: Ford F250 SD, 2wd. Replacing front bearing
leave nut etc... off and place wheel on spindle, screw lug nuts on about half way and shake tire in and out untill spindle comes loose make sure u have vehicle supported securely never trust a jack!!
If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_00678fd4800d19c5
SOURCE: 1999 ford f250 super duty 4x4 will go into 4
transfer case selector switch or equivlent to is bad or connectors to the switch is bad dose it do only when it rain or moisture underneath.
SOURCE: I need the wiring schematics for a 1999 Ford F250
You need to specify that if the diagram engine or that. Thanks
1,700 views
Usually answered in minutes!
×