Here are some step by step instructions
https://www.fordforumsonline.com/threads/how-to-remove-the-radiator-in-a-windstar.8527/
SOURCE: how do i remove the armrest on my winstar
The real real answer. If the threaded stud is in the armrest there is a clip at the bottom of it you have to push it up and pull the stud out with vice grips twisting as you pull out. If both the studs are in the chair you have to make sure the clip is pushed up & out of the way then simply line up the arm rest and push it on. It should clip into place. Hope that is clear enough. Also I would put some Lock Tight on the threads. (Blue)
SOURCE: Broke axel right front. I
Hi, Thank you for contacting
fixya.com. Set the vehicle
transmission in "Park" and engage the emergency brake before attempting
to remove the front right axle. Place wood blocks behind the rear wheels to
prevent the vehicle from rolling and loosen the lug nuts one complete turn on
the right front wheel with a tire tool. Lift the front passenger
side of the vehicle with a floor jack and slide a jack stand under the vehicle
frame near the wheel. Lower the floor jack so the vehicle is sitting on the
jack stand and move the floor jack out of the way. Remove the lug nuts with
the tire tool and set the front passenger wheel out of the way. Take the cap
off the end of the axle with a standard screwdriver and remove the cotter pin
from the axle with a pair of pliers. Slide the crown washer
off the axle and loosen the axle nut with a crescent wrench. Unfasten the top
and bottom bolts that secure the brake caliper to the rotor with a socket
wrench and slide the bolts out of the caliper. Lift the brake caliper
off the rotor and remove the brake pads from the caliper. Suspend the brake
caliper from the vehicle frame with a wire hanger and take the rotor off the
axle. Unfasten the thru-bolt
on the vertical sway bar with a socket wrench and remove the bolt from the sway
bar. Take the channel bolt out from between the sway bar and lower A-arm that
the thru-bolt ran through, and loosen the bolts that secure the front right
axle to the center flange with a socket wrench and breaker bar. You may need to
loosen the bolts with the breaker bar before removing them with the socket
wrench. Slide the front right
axle off the center flange and let it rest on the A-arm. Lift the front
passenger side up with the floor jack to get enough room between the steering
knuckle and A-arm and slide the axle out of the vehicle. http://www.ehow.com/how_7804107_replace-assembly-2001-ford-windstar.html Please get back to us if
you have further query else please accept the suggestion.
Please check this link
if it helps:-
228 views
Usually answered in minutes!
×