The best solution you'll g et from books at www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc
SOURCE: check engine sign flashing. i have an auto repair
first of all check the fuses
check to see if there is any spark, no spark check ignition system
check fuel pressure, no pressure then check fuel pump
if there is pressure and spark then check to see if fuel injectors work
if no spark and no fuel injector check crank sensor, ignitor and wirings
SOURCE: my isuzu dmax oil pan
In order for that dent to have any real effect upon oil delivery, the dent would need to be perfectly flat up against the oil pump pickup. Chances are it isn't. The pickup in most pans is located a bit above the pan bottom to lessen the chance of ingesting any contaminants (sand, grit, hard carbon etc). With the clearance diminished, chances of that are greater.
While only oil pressure is measured, volume is also important. With the pan that close to the pickup, pressure probably won't be a problem but you may loose some volume (impossible to tell how much).
When I put together a fresh engine, I like to see pressure of about 40psi or better. As an engine wears, engineers claim that anything above 15psi is OK...I use a higher number of 25psi (at idle) as a minimum "safe" limit. Anything below that, you know you have a problem and it's wise to find it early and fix it. (Pumps rarely fail...most low pressure problems can be traced to engine bearing wear, resulting in bleed off past the bearings)
As for your pan: If the pan is bent, and you have it off the engine, why not hammer the bend out a little? or, better yet, get another pan from a scrapyard and replace it entirely?
If you have not removed it, there's no real way of measuring and what you are seeing may not be the whole story...pickup clearance may be greater elsewhere. In that case, just continue doing regular service and save pan replacement for a day when you have time to do it.
SOURCE: isuzu DMAX sudden power loss
could be fuel filter clog.air filter or MAP sensor or an intermittent speed sensor on the transmission
SOURCE: Isuzu dmax 2006 model 4x4 automatic transmission, the check trans is flashing
With the engine running and the e-brake on, put the vehicle into neutral. Pop the hood, and check the level of transmission oil on the dipstick (Yellow).
scan the PCM. see MAF failure.
push reset on tool (a button there) and now it gone.
or drive until it self clears, can be long waste of time.
or pull the memory fuse to PCM. count 5min, put back.
id not pull battery neg lug or make more work and pain.
714 views
Usually answered in minutes!
×