Door removal 1999 ford escort - Ford Cars & Trucks

SOURCE: Ford Escort 1999

break light

SOURCE: how do i change brake pads on my 1999 ford escort

pull the pins out. the clips hold them in place. use a large screw driver and seperate the pads from the rotors. pushing them away from the rotors to make room for the new ones. good luck

SOURCE: 1999 ford escort zx2

Hey It is vary simple, first you must loosen the belt. There should be a diagram in you manual or something that originally came with the car if not look it up on google. there is a certain pulley that will loosen the belt when cranked upon. do this and it will make things much easier than i think there are 3 bolts holding it in. And I'm pretty sure when i did it i could get all of them from underneath the car. after you take these three bolts out there are some apparent wres that need a little disconnecting and WALLA its out. than when you put a new one back on dont forget to re tighten the belt with the same pully.

SOURCE: How do I remove the door panels to change the

remove the front door pull cup screw
remove the screw cap and screw from inside handle and slide the handle rearward to disengage the hook from the inner sheet metal. disconnect inside handle from latch remote link if manual windows- remove crank with store bought remover tool. Remove the 2 pushpins from the door trim panel using trim tool pry away door panel [7] fasteners holding panel and push panel in and up . if elect windows disconnect switches

SOURCE: how do you remove

The dip stick tube is pressed into the engine block. Put a bolt into the top of the tube so that the body of the bolt goes into the tube and the bolt head rests on the tube (so it does not fall down the tube). Use a wrench (such as a Vise grip) to hold onto the tube at the bolt and gently work it back and forth, being sure not to deform the tube. Remove the tube and old dip stick. Replace the tube by forcing it back into the eng. block. Replace the dip stick - done :)! Some dip stick tubes have a gasket at the engine - others just **** up to a shoulder that is built into the tube. Let me know if this works. Thanks.