Is anything I can do? Don't know , do you know how to test electrical circuit's using a DVOM - digital volt ohm meter ? Do you know what a wiring diagram is an how to read one ?
P2008 - Intake Manifold Runner Control (IMRC) Circuit Open (Bank 1)
Description:
This DTC indicates a failure in the IMRC primary control circuit. This DTC replaces P1520.
Possible Causes:
Diagnostic Aids:
Monitor the IMRC and IMRCM PIDs. The IMRCM state should change when the IMRC is commanded open or closed.
Application
Key On Engine Off
Key On Engine Running
Continuous Memory
All
GO to Pinpoint Test HU .
P2008 code on 2005 ford focus
SOURCE: INTAKE MANIFOLD CONTRL RUNNER VAVLE LOCATIONS
they are on the back side of the motor just above the transmission .take off the dog house and you will see the unit.
SOURCE: I have a '96 Ford Windstar 3.8L & getting OBDII P1537 code.
A common problem on Windstars, there are two IMRC valves, the only way to fix them is replacement, which is not that hard. They are mounted on the end of the intake manifold and control runner length. There is a front and rear one, I'm not sure which one this is but you'll probably have to go to Ford to buy it and they should be able to tell you with the code number. The problem will not affect driveability that much, but if you have emissions testing at your location, this will likely cause it to fail.
SOURCE: 1998 ford windstar 3.8 with code p1538. Is this a
LOOKING IN CODE BOOK.POSSIBLE CAUSE TO YOUR PROBLEM THE IMRC COULD BE STUCK OPEN.OR THE IMRC ACTUATOR IS DAMAGED OR HAS FAILED.ALSO THE IMRC MONITOR SIGNAL CIRCUIT COULD BE SHORTED TO POWER GROUND OR SHORTED TO SIGNAL GROUND RETURN.
SOURCE: ford focus p2008 engine code??
Check pcv hose from the manifold to pipe. It will get soft and collapse, leak. It will turn light on. Check while running.
SOURCE: P2008 Intake Manifold runner control
Hi.
P2008 means intake runner control circut/open bank 1. The intake mainfold running solenoid must be checked and eventually replaced. The solenoid is located off the vacuum hose and operates the intake runner shaft throught the mainfold.
Regards.
Ginko.
1,067 views
Usually answered in minutes!
×