Will I need to do any reprogramming to the computer to compensate for the change?
SOURCE: 2005 Mustang GT idleing problem
may be it the problem of another throttle body.also check the ignition switch.
Check all of the battery terminals and cables and check the wires on the starter/selonoid, start from the battery and follow the cable out and check all conections , clean and tighten them and if it still does it the starter/selonoid is bad and needs replacement...
SOURCE: Cant find transmission filter on 2003 Dodge stratus Coupe.
The filter is inside the transmission. You need to take the pan off the bottom then you can replace the filter and the pan gasket.
SOURCE: 2001 Acura 3.2 CL Type-S TPS and Map sensor issues...
no need to replace the throttle body , and i think that you make a test before to buy any piece . disconnect the negative battery terminal few minutes, then connnect and start engine again, drive few minutes by observing the engine, if light comes again, replace only map sensor ,good luckl
SOURCE: 06 crown vic stalls out when full throttle
put these codes directly one at a time on google search and you will find the result
SOURCE: I need torque specs for the head bolts on a 2004
For 2004 Dodge Stratus 2.4L SFI SOHC 4cyl the Head Bolt Torque sequence
------------
| 10 6 2 3 7 |
| 9 5 1 4 8 |
------------
Step: 1 - Torque to 25 ft/lbs
Steps: 2 - Torque to 50
ft/lbs
Steps: 3 - Torque to 50 ft/lbs
Steps: 4 - Turn 90 degreesRecheck
final torque in sequence
Caution:Engine uses torque to yield head bolts
(TTY) that permanently stretch during initial installation. New head bolts
must be used when cylinder headis replaced or re installed to obtain
proper torque specification.
Hope helps (remember comment and rated this).
Testimonial: "I appreciate your quick response. Thanks"
306 views
Usually answered in minutes!
×