SOURCE: firing order for 1997 jeep cherokee straight 6 cyl.
153624 On cap #1 is two towers clockwise from right side hold-down screw, #1 is front cyl on engine. Firing order is clockwise.
SOURCE: 1998 Jeep Grand Cherokee Laredo 4.oL I got a code po113
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input
Print this code data
Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Possible Causes:
SOURCE: I have a 2002 Jeep Grand Cherokee, 6 cyl. no reverse
if you cant rebuild then off to the tranny shop
SOURCE: fuse box diagram for 1995 jeep grand cherokee 6
EMAIL ME I CAN CAN EMAIL YOU THE LAYOUT
[email protected]
SOURCE: i need to know where the oil pressure sensor is
It is located on the right passenger side of the engine near the oil filter housing. It threads into the engine block. It may also be located near the distributor on some 1996 models. Disconnect the single wire connected to the sensor, and use a socket to remove it. Wrap the threads of the new one with teflon tape, and install the new one hand tight and then tighten it 1/4 turn more with the socket. Reconnect the electrical connection.
204 views
Usually answered in minutes!
×