Question about Chevrolet Express
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: chevy van won't start
Check for spark and fuel. If you have spark make sure your fuel pump is working. If pump is working and no spark, check for spark off coil wire. If nothing there either, remove ignition module and take it to Napa and have them check it. Have them test it several times.
Posted on Jun 12, 2008
Check Timing #1 Top Dead Center on Compresion Stroke And Look At Rotor Position If it Is Pointed at #1 On Dist Cap If Not Timing Chain Is the Problem<<
Posted on Feb 11, 2009
You need to replace the handle itself. The inside of the handle where the metal cable fitting attaches causes too much strain on the plastic and the molded groove breaks. Ford has the same problem. I don't know why these car man. dont just go back to all metal exterior handles. If you have time you can probably fix it with epoxy and washers, but the fastest way is to get one aftermarket or from a junkyard. Hope this answers your question.
Please remember to rate this fix.
Posted on Feb 14, 2009
Start with fuel system. Listen for fuel pump humm at fuel tank No humm check wiring to pump for power. Then check for spark at plugs and wires. Remove wire from coil and hold near engine and see arch when you crank. No arch. Replace ignition Modular inside distributor cap or cap or rotor
Posted on Feb 04, 2010
Tips for a great answer:
Oct 16, 2017 | Cars & Trucks
Mar 01, 2013 | Chevrolet Express Cars & Trucks
Jun 08, 2010 | 2000 Chevrolet Express Cargo
May 08, 2010 | Chevrolet Express Cars & Trucks
Feb 04, 2010 | 2000 Chevrolet Express Cargo
May 27, 2009 | 2002 Chevrolet Express
Aug 10, 2008 | Chevrolet Cargo Cars & Trucks
Jun 22, 2008 | 1993 Chevrolet S-10 Blazer
29 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: