SOURCE: engine overheating
No water pump issues I am aware off, are you sure you bled the air out of the cooling system? If not fill the overflow bottle all the way full, then use a floor jack and raise the front of the car as high as you can ( this allows air to go to top of radiator tank), then run the engine at high idle speed until the cooling fan ( I assume the fan works OK?) comes on, but avoid letting the engine get into the overheat area of the guage, if it does turn it off, run water over the radiator until it cools, check the tank and radiator, top off if you need to and repeat above procedure, if this doesn't work you have some other problem like no or little flow in radiator.
SOURCE: The heat in my 1992 Jeep Wangler is not working.
Hi!
It
appears we have an Air lock scenario and you will need to perform a
system Bleed.
Park
the vehicle on level ground, when cold remove coolant filler cap,
start engine and leave to idle, turn heater on full and blower to
max. When engine reaches operating temperature watch and listen near
coolant filler, keep clear as gurgling and hopefully a boil over
should occur. Top up with very warm coolant and wait as it may do it
again.
Check
for heat inside vehicle if warm replace coolant cap but keep an eye
on temperature gauge as the ~Air lock may have moved on from heater
matrix/core so proceedure needs to be carried out again from COLD.
If
persistent boil ups/over attention must made in the cylinder head
or
gasket area, or possibly water pump?
Please
press the Blue button to appraise my FREE Efforts, Thank You!
Paul
'W' U.K.
SOURCE: overheating
then the water pump must be bad in it .Take the rad cap off and rev motor up if it goes down the the pump is working if it spays of look at the head gasket being damaged .Check and make sure spark plugs are not wet either if one is soaked signs of a leaky head gasket
SOURCE: 1999 ford taurus no heat
Is the blower motor working? If not that is what it is. If it is working then check heater coil out, Could be bad heater coil.
SOURCE: 98 sable -no heat. changed thermostat, new
Since your blower is working and it is a heat issue,thats where we'll
start,First thing is have you checked the coolant level in the radiator when
engine is cold,make sure it is filled to top,next verify you have coolant in
reserve ,Start your van and get it up to normal operation temperature,If your
heat gauge on the dash works correctly it should be 190 degrees,Now lift the
hood and locate the two heater hoses going into the heater assembly at the fire
wall,Both hoses should be hot to hold on to,if both are hot and no heat inside
your problem will be the blend air door in heater assembly.
if neither hose
is that hot you need to replace the thermostat in the engine to get it up to 195
degrees.
if one hose is hot and one is luke warm then the heater core is
blocked and to blame. hope this helps you.
276 views
Usually answered in minutes!
×