SOURCE: 1997 Toyota corolla - warning noise when lights left on - not working on drivers side!
The ground circuit for the driver side door switch is compromised, or the door switch is bad. Try this: Remove the black rubber cover from the door swich. Using a 10 millimeter wrench or socket, loosen & tighten the switch retention bolt. See if the dome light flickers. If so, the ground on the switch is bad, & just needs cleaned up. If not, remove the switch, and touch the wire behind the switch to the body,or the bolt hole. If the dome light lights, you need a door switch. Your problem is entirely in the door switch/ground/wiring. Hope this helps, and thanks for choosing FixYa.
SOURCE: 2005 f150 "Door Ajar Light Always On.. Even with all doors shut..
What happens when you remove both switches, and wires? What happens when you use a jumper wire acros both wires, on both doors?
SOURCE: diagnose 'check engine' warning alarm
might be some electrical problem, because, Suzukis are mostly controlled Electronically, it may represent a malfunction!!
try contacting an electrition!!
SOURCE: 2003 Volkswagen Jetta Door Ajar Light wont turn off and car alarm
The problem you are experiencing is the drivers side interior light switch is not working. This is usually found in the door latch on later model cars and usually requires the complete latch mechanism changing. However it would pay to check that your car doesn't have a pin switch fitted in the pillar.Unfortunately I think you have the former.
SOURCE: Was washing and waxing 1997
put key in door lock,unlock/hold key over windows will go down....then lock/hold key over,windows will go up,press and hold unlock button on remote for 30 secs,you have just reset the alarm/immobiliser.
Testimonial: "Also found out that locking and unlocking the trunk will reset the alarm function. Thank you."
527 views
Usually answered in minutes!
×