I have found a replacement fuse box at salvage yard. how do I connect wires to it?
I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. It would'nt move forward or reverse, engine was good both solenoids
for forward and reverse worked, but still couldn't diagnose the problem.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.comAll the best
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: I have lost the spray nozzles on my 2003 Saturn
you can buy universal ones at places like autozone, walmart, etc
SOURCE: 1991 Century Buick V6 starter replacement.
remove the positive battery cable from the post
remove the 3 wires from the starter and the two bolts holding the starter to the block.
reverse the procedure for installation.
Testimonial: "I know that there is usually only 2 bolts to remove a starter. I've identified one bolt but was not sure about the location of the other one. Thanks"
SOURCE: the light behind my odometer in my 2003 buick
the odometer is not working on my 2003 Buick Century, the mechanich suggested to have ot replaced with a rebuilt.. any suggestions, where to find one, how to fix, soluctions, ideas?
101 views
Usually answered in minutes!
×