Question about 2004 Chevrolet Avalanche

1 Answer

Vehicle is a 04 avalanche and it was hit while parked on passenger side rear quarter panel

After body work drove less than a mile abs light came on code co268 I feel this was damaged when hit is this possible it says abs module bad tested for power power going to.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 34,288 Answers

Id be checking that right rear abs sensor and wiring

Posted on Feb 24, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 333 Answers

SOURCE: 1989 oldsmobile cutlass ciera 3.3L V6 power antenna broken

You need to access from outside the vehicle. You have to remove the shroud that is inside of the wheel well. It is not a very easy task I hope this helps.

Posted on Feb 04, 2009

Anonymous

  • 295 Answers

SOURCE: 2005 impala

All the hubs on the car have the abs sensor built into the hub. The abs system has to be re set to read the sensor . The rear hub bearing if noisy should be replaced. There are wiring harnesses that connect to the abs sensor. The harnesses to each of the abs sensor should be replaced.

Posted on Mar 18, 2009

Jonah Oneal

  • 14092 Answers

SOURCE: 2000 LINCOLN LS, WELL WHEN THEY DID THE TEST THE

MAKE SURE YOUR CAR BATTERY AND ALTERNATOR IS IN GOOD OPERATION.HAVE THEM TESTED.I HAVE SEEN A CAR WITH ABS AND AMPS LIGHTS ON.THE ALTERNATOR WAS NOT PUTTING OUT ENOUGH VOLTS TO RUN THE ABS BRAKE SYSTEM. IF ALTERNATOR AND BATTERY IS GOOD.I WOULD REPLACE THE ABS RELAY FIRST.ITS GOES BAD CAUSE THE ABS BRAKES NOT TO WORK.IF ABS RELAY IS GOOD.THEN IT HAS TO BE ABS MODULE GOING BAD.IT HAS TO BE REPLACED.

Posted on Jul 26, 2009

Anonymous

  • 75 Answers

SOURCE: FRONT PASSENGER SIDE POWER WINDOWS

sounds like your wendow regulator is going out

Posted on Aug 15, 2009

hw0214

  • 2 Answers

SOURCE: where is the bcm(body control module) on a 2001

BCM on the 2001 durango was also known as the CTM but regardless it is located on driver side kick panel where your left foot would be if you are driving. there is two screws to remove panel. its a black box with three plug ins.

Posted on Feb 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

What would cause abs light, jumpy speedometer,rough shifting, air bad light, and brake lights to stay on in 05 silverado?


bad or damaged body ground---chaffed/damaged wire or wire harness and bcm-[body control module ] going bad or harness damaged

Jul 11, 2016 | 2005 Chevrolet Chevrolet Silverado 1500

2 Answers

We have a 2002 Ford Taurus with 77000 miles. It was running great but now when we hit the highway or when we go around 50-60 mph the trac control indicator goes off and the car don't accelerate. It feel...


Sounds like you have a bad speed sensor on the ABS. Have the ABS scanned for codes. If you want to test this, unplug one of the speed sensors. The ABS light should come on and disable the traction control system. Then the transmission should work fine. If it does, diagnose the ABS/Traction control system.

Jul 07, 2009 | 2002 Ford Taurus

1 Answer

Turn off check engine while abs control module is not connected


have vehicle checked for trouble codes any autozone or parts store most will check it for free .You should than have an idea what is still wrong. If you feel this was helpfull please leave good feed Back

Dec 23, 2014 | 2008 Hyundai Tucson

1 Answer

Turn lights clicking noise


Without testing the electronic's , hooking up a professional type scan tool an checking for DTC'S - diagnostic trouble code's etc ... we'd only be guessing . Probably the instrument cluster,but that is just a guess . Are you aware that the instrument cluster has a microprocessor an logic . Serial data communication network the modules share info. on ? Your vehicle has 10 or more modules (computers ) . What's the voltage at the battery terminals with the vehicle running ? Viewing wiring diagrams for electrical distribution an testing with a DMM - digital multi-meter would be a next step in the diagnostic procedure ,if no code's !
Electric Testing Techniques You Need to Know

Free wiring diagrams here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model an engine size . Under system click on body & accessories ,then under subsystem click on instrumentation . Click the search button then the blue link. Pull the instrument cluster ,with it still connected to the vehicle , check power an ground circuit's .

Dec 01, 2017 | 2002 Ford F250 Super Duty SuperCab

1 Answer

I replaced both front hubs due to possible bearings being bad. My 2005 explorer has 120,000 miles and runs strong. After the hubs were replaced, the "ABS", "4x4", and...


The ABS has been deactivated but the normal barkes are still active. This is why your brakes run fine now. You might have damaged the sensors or the tone ring. The tone ring is made up of teeth that the sensor reads. If one of them are damaged, the computer will miss diagnose your problem and the ABS light will turn on. Good luck!

Aug 30, 2011 | 2005 Ford Explorer

3 Answers

Why is the Abs light is on when it is nothing is wrong with the brakes?


the abs light is on because the automatic braking system has a problem yes it is still safe to drive but if you go into a wet condition and slam on the brakes you might go into a spin without the abs to keep you straight.usually its a wheel bearing sensor that's bad but can also be the control module best to go over to a auto zone or advance auto parts to get it checked for free.hope this helps you please vote if so.

Apr 26, 2010 | 1995 Honda Accord

5 Answers

2006 GRAND VITARA ESP LIGHT ON


I have the same problem, my 2006 has less than 50,000  miles and light is on....does it really matter, or is the light just somethings that comes on 

Sep 18, 2009 | 2006 Suzuki Grand Vitara

1 Answer

2000 LINCOLN LS, WELL WHEN THEY DID THE TEST THE CODE WAS B1342 ABS MODULE, THEN IT WAS TEST DROVE & EVRYTHING WAS OK BUT WHEN I DROVE IT ALL THOSE LIGHTS CAME BACK ON & ARE STILL ON, ....REPLACE...


MAKE SURE YOUR CAR BATTERY AND ALTERNATOR IS IN GOOD OPERATION.HAVE THEM TESTED.I HAVE SEEN A CAR WITH ABS AND AMPS LIGHTS ON.THE ALTERNATOR WAS NOT PUTTING OUT ENOUGH VOLTS TO RUN THE ABS BRAKE SYSTEM. IF ALTERNATOR AND BATTERY IS GOOD.I WOULD REPLACE THE ABS RELAY FIRST.ITS GOES BAD CAUSE THE ABS BRAKES NOT TO WORK.IF ABS RELAY IS GOOD.THEN IT HAS TO BE ABS MODULE GOING BAD.IT HAS TO BE REPLACED.

Jul 26, 2009 | 2000 Lincoln LS

Not finding what you are looking for?
2004 Chevrolet Avalanche Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...