SOURCE: changing the tail light bulbs on a 2000 mazda 626
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
SOURCE: egr valve on ford 98 ranger, ck. eng. light on
disconnect it and seal it off with a piece of broom handle in the inlet side.sounds drastic i know but it works.
SOURCE: Treated gas for moisture. Got high octane additive.
Even a small amount of bad gas can cause your problem.
So the first thing you need to do is remove your fuel tank so you can drain all of the old fuel out,then remove the fuel sending unit and fuel pump assembly thats in your fuel tank and clean the filter screen, after that you can reinstall the fuel tank,replace your fuel filter and I would have a fuel injector sevice done.
Unless you are very skilled in automotive repair, leave this one to a pro.
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: 2000 mazda 626 check engine light went on . code
probley not egr valve it probley egr control solenoid or wiring
65 views
Usually answered in minutes!
×