Where would I find the idle control sensor on a 2007 Suzuki Reno dtec 16 valve

5 Related Answers

Anonymous

Posted on Sep 10, 2008

SOURCE: 1995 suzuki sidekick 16 valve

Check throtle position sensor... one section closes a set of contacts when you take your foot off the accelerator... this is sent back to the engine control computer which adjust the timing to insure the engine stays @ ~ 800 rpm. It's easy to set with just a simple multimeter...

hotrod88lsc

60 Answers
Posted on Aug 18, 2009

SOURCE: replacing the transmission range sensor Suzuki Reno

Nope, disconnect the battery before install and reconnect it when your done.

Testimonial: "Thank you so much!!"

Anonymous

376 Answers
Posted on Sep 15, 2009

SOURCE: how to fix an idle problem in my car

most cars have whats called the IAC (Idle Air Control) sensor, but other sensors can cause the same problem. fords have a bad problem with these sensors. keep in mind it is not always a sensor, but in most cases this is a successful fix. good luck!

Anonymous

5081 Answers
Posted on Dec 19, 2010

SOURCE: What grade of oil doe

Suzuki recommends 10w30 grade oil and it will need about 2.4 quarts of oil without a filter change and 2.6 with a filter change.

Anonymous

1 Answer
Posted on Mar 09, 2012

SOURCE: replaced egr valve pressure sensor upstream and

where is da egr control solen noid located on the 1996 ford explorer?

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

How to reset a computer on a 2006 suzuki reno 2.0 16 valve

You can disconnect the battery for 5 min but you lose the codes. Try to use OBD scanner to get a code and what the problem is.

Read full answer

Jan 25, 2019 • 2006 Suzuki Reno

0answers

Hi I'm anthony I have a 2005 suzuki reno I think it's a grate car so I'd like to beef it up with a bigger motor what engine do u think would be best fitting for low budget rebuild?

Read full answer

Be the first to answer May 12, 2016 • Suzuki Cars & Trucks

0helpful

1answer

How to adjust engine idle on 2007 suzuki reno

there is no such thing, and dont try,
the PCM controls idle at all times. (via the ISC device)
alldata.com, and the real FSM states just that.
read it.
my wild guess is , idle is wrong.
so is wrong, when cold, warm or hot engine
and what is it, in RPM?

Read full answer

Sep 21, 2014 • 2007 Suzuki Reno Hatchback

0helpful

1answer

Location of the the low tire pressure sensor light in a suzuki reno 2007

the cluster lamp, well that's easy,
turn key, all lights i dash glow as a test. see it TPMS
or open up glove box operators guide, see that page telling you same? and more.. on topic, lost it get one?

4 bucks a gander
https://suzukipitstopplus.com/Products/1067-2007-reno-owners-manual.aspx

same for FSM book (service), see it? see both?

Read full answer

May 23, 2014 • 2007 Suzuki Reno Hatchback

0helpful

1answer

How do i reset the low tire pressure light in a suzuki reno 2007

TPMS #2 old post, and rare on this topic so will answer.
next post adds how to reset it,?
now that is a loaded question avoiding all systems,,,,,
YOU dont., it's Automatic for 4 bucks you can read the whole
full rules in the FSM.
https://suzukipitstopplus.com/Products/1068-2007-forenza-reno-service-manual.aspx

did you use a scan tool yet, most cars will tell you which tire is wrong. (are the all at spec pressure? ) including spare?

steps to take in all cases
1: tire pressure correct.
2: connect any scan too (can-bus) to dash DLC 16 pin connector
3: keyon and scan.
4: see DTC C0750 (or many others0 750 is.
Transmitter Battery Voltage is too low. tire #1

this is first, repairs are next. (actually more tests)
we have a hand scanner now cheap, to scan all tires.
(battery bad, pressure low, dead, or? other errors on sensor, even too hot)

Read full answer

May 23, 2014 • 2007 Suzuki Reno Hatchback

0helpful

1answer