How to install fog light assembly Jeep Commander 2008

SOURCE: location of oil dipstick

The oil dipstick is located at the back of the engine.  If you look at the engine from a top view it is located at about 11 o'clock.  It's black.

SOURCE: Jeep Commander Rear Brake Pad Installation

Per Chilton Auto repair manual:

Removal & Installation

1. Raise and safely support the vehicle.
   
2. Remove the rear wheel.
   
3. Siphon a small amount of brake fluid from the master cylinder reservoir.
   
4. Insert a small prybar through the caliper opening and pry the caliper cover (using the outboard brake pad) to bottom the piston in the caliper bore.
   
5. Remove the caliper slide bolts.
   
6. Remove the caliper from the anchor.
   
   WARNING Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
   
7. Remove the brake pads from the caliper.
   

1. Install the brake pads onto the caliper.
   
2. Lubricate the slide pin bolts with grease provided with the brake pads, or suitable silicon grease equivalent.
   
3. Install the caliper on the anchor and tighten the slide pin bolts to 18 ft. lbs. (25 Nm).
   
4. Install the rear wheel.
   
5. Lower the vehicle.
   
6. Pump the brake pedal several times until a firm pedal is obtained in order to properly seat the pads.
   
7. Refill the brake fluid reservoir to the proper level.
   

SOURCE: Fog Light Bulb 2008 Elantra

Simple to do.

Mike Raatz

• 435 Answers
• Posted on May 21, 2010

SOURCE: install a altenator for a 2006 jeep commander

I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

SOURCE: 2008 frontier king cab 4x4 installing fog lights

Yeah it should be OK..nothings wrong with that