Remove and replace front left fender 09 Saturn Aura

SOURCE: Is it true that you

Depends on how hard you want to be on yourself. It Can be done if you've the flexibility of speghetti, but save time and do it right...accordianmn

SOURCE: replace front fenders 1999 wrangler

Hi! In your case you have to read this STEP by STEP instruction how to replace fenders

1. First, raise the front of the car and rest it securely on jack stands.
2. Remove the front wheels (the fender can be removed with the wheels on, but you'll have limited access to the fender bolts -- we recommend removing the wheels).
3. If you're removing the left front fender on a 1968 through 1973 model, unplug the horn wires and remove the horn. Don't hang the horn by the wires.
4. Remove the bumper and bumper brackets
5. First remove the headlights and turn signal lights and wrap the wiring up out of the way.
6. Remove the nut, washer and bolt that attach the fender to the running board.
7. Remove the bolts and nuts that attach the fender to the body.
8. Remove the fender, the beading, and the rubber spacer between the fender and the running board. Note: The rubber bead has cutouts around the bolt holes (it doesn't have holes in it - just cut outs).
   
9. Inspect the rubber beading and the rubber spacer washer. If they are cracked, dried, or deteriorated, replace them.
   
   
10. Check the threaded holes in the captive nuts in the body and clean them up with a tap if necessary. Lubricate the bolt threads.

1. Place the fender in position against the body without the beading and loosely install one bolt at the top to support the fender.
2. Now start the rest of the bolts. Tighten them just enough to hold the fender in position.Install a new rubber spacer washer between the fender and the running board, then install the bolt, washer and nut that attach the fender to the running board, but don't tighten yet.
3. Hold the new beading around the body immediately above the fender, and mark (with chalk) the locations of the bolts. Cut slots in the portion of the beading the extends down between the body and the fender to accomodate the bolts, then push the beading into place with your hand. Make sure the slots in the beading slip over the bolts. Be extremely careful about the fit of the beading as you gradually and evenly hand-tighten the fender bolts a few turns.
4. Gradually and evenly tighten all the bolts.
5. The remainder of installation is the reverse of removal. GOOD LUCK thanks
   

SOURCE: How do I change the fuel filter on an 08 saturn aura xe?

According to other forums I checked, the word is that the fuel filter is in the fuel tank and does not need to be replaced. I would simply call a Saturn Dealer service department and confirm that this is true.

SOURCE: Remove left front fender 1967 Chevelle

There are quite a few bolts on this fender. One on the bottom of the rocker, one between the the door and fender on the "A" pillar, one on the cal, one on the firewall then several on the inner fender and several on the radiator core support. after these are removes you need to take ou the head light assembly and you should have a fender brace under the front of the car. Hope this helps.

SOURCE: remove and replace 1998 volkswagon Jetta Fender

how do i remove pump on inside of right fender?