Question about 2006 Chevrolet Cobalt

Open Question

2006 cobalt runs but when i put it in any gear it doesn't want to go any where so i have it running put it in 2nd gear and took my foot off the clutch to see if it would stall or continue to run

I dont know what part of the clutch needs replaced

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
66 chrgr

mike loshbough

  • 1011 Answers

SOURCE: 2000 durango 5.2 cold starts, engine stalls or rpm surging

i know this may sound stupid but if your battery is old or a little weak on this vehicle the idle air control solenoid will act speradicley hunting for were it should be and the vehicle will stall.replace battery

Posted on Feb 01, 2009

Ad
greg_margo

Greg Margossian

  • 1959 Answers

SOURCE: Cobalt not running at low rpm.......

All are possibilities but EGR valve makes the most sense. It's famous for causing poor idling and/or stalling at low RPMS. Best of luck.
Greg

Posted on Jun 18, 2009

Anonymous

  • 2 Answers

SOURCE: runs great,put in gear stalls

You have some kind of sensor bad. Get it checked by a pro ; - )

Posted on Jul 17, 2009

Anonymous

  • 169 Answers

SOURCE: runs but not change gears

if the speedo works sensors ok what trans in car 3t40 or 4t40e can you shift it manually or will it finally shift at red line

Posted on Aug 29, 2009

chris quammen

  • 811 Answers

SOURCE: Car will start but will not stay running-not getting gas?

have fuel injection system cleaned

Posted on Oct 03, 2009

Testimonial: "Thank you for the quick reply. This was one of my first thoughts along with possibility of a blocked fuel filter, fuel pump, or plugs/coil connectors."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2006 chevy cobalt wont run in drive it dies but will run good in reverse


On some old Buicks and Oldsmobiles the overdrive would stick on. A bandaid cure for them was to unplug the cable under the hood, but you no longer had overdrive. I heard that changing the transmission fluid would clear that up. There's no overdrive in Reverse.. placing the car in 1st or 2nd gear could bypass o/d also if they don't use the same gear set. Once up-to-speed, place the car in Drive. This only works if the reason the car dies is it can't accelerate in that high a gear at such a slow speed.

Oct 12, 2015 | 2006 Chevrolet Chevrolet Cobalt LS

1 Answer

Transmission


The light being on has probably put the car in "limp in" mode. Its a kind of fail safe system to allow car to be driven to a shop for repairs. You need to have the code or codes read by scanning the engine computer, repair the problem, erase the codes, and then you should be able to drive it again normally.

Jun 08, 2013 | 2006 Chevrolet Cobalt

1 Answer

I have a friend who recently put on a fanbelt in his 2006 Chevy Cobalt and now the air conditioner doesn't work. Could he have just routed the belt wrong?


more then likely, he did not put it on right! good-day! if it was ok before and does not work now, then the belts on wrong.

Aug 29, 2011 | 2006 Chevrolet Cobalt

1 Answer

Problem salecting 2nd gear , 115 thousand mills on clock year 2006 1.9 tdi avant s line is this clutch or gear box ?


if you put your foot on the clutch all the way down,and then try ALL the gears when stopped.if they engage,without applying any force,then its the gearbox,possibly the baulk ring.

Feb 23, 2011 | 2006 Audi A4

1 Answer

2006 chevy cobalt LT. the key is stuck


Have you tried shifting the gears completely through and then putting the car in park. It sounds like the car isn't able to be put completely in park to release the key. Try putting the car in N and removing the key. Even thought the car may not completely be in park to release the key, The gear most likely is in park but not enough to make the switch/sensor to release.

Jul 16, 2010 | 2006 Chevrolet Cobalt

1 Answer

2006 cobalt overheating while IDLE


go ahead and have the thermostat and the thermostate switch replace since its giving you a sign, you don't want to have it overheat and leave you stranded or ruin the motor. the fans seem to work fine since you can hear and see it running.

Nov 10, 2009 | 2006 Chevrolet Cobalt

2 Answers

2006 trailblazer ss automatic transmission problem


You friend broke the low one way clutch. He was rolling backwards and shifted into drive and floored it before the vehicle came to a stop.

Jun 28, 2009 | 2006 Chevrolet Trailblazer

2 Answers

I can't remove key from chevrolet cobalt


try the ignition switch. i had the same problem

Dec 31, 2008 | 2007 Chevrolet Cobalt Coupe

Not finding what you are looking for?
2006 Chevrolet Cobalt Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...