SOURCE: I need a diagram to fix serpentine belt for 2004
IF THERE IS NOT A DIAGRAM UNDER THE HOOD ANY LOCAL AUTOPART STORE SHOULD B ABLE TO PROVIDE ONE 4 U, TRY AUTOZONE OR NAPA THIS SERVICE IS FREE
If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_00678fd4800d19c5
SOURCE: I need to replace the crank sensor on a 2004
If you lay on your back and slide under the front bumper just past the radiator you will see the oil filter housing. It is on the block next to the filter housing on the right side That is where it is on my 2003 l300.
SOURCE: 2004 saturn l300 heater fan motor cuts in and out
Check connections to the fan speed resistor module for looseness, and the resistor module itself for heat damage or intermittency.
The resistor module is in the heater fan ducting in the fan airflow.
Alternatively, the fan motor may be faulty (or have worn brushes)- apply power directly to the motor supply connections to ensure it runs ok.
SOURCE: looking for a diagram of
check on the follwoing links and post your queries:
http://l3002engine.info/
http://www.getusedparts.com/automobile_guide/saturn/l300_engine.html
SOURCE: HOW DO YOU REPLACE REAR BRAKE PADS ON A 2004 SATURN L300 WAGON
You have to remove the brake line, cap it with the cover for the bleed valve, then unbolt the caliper (two bolts), pull the caliper, remove the old pads, compress the piston back into the caliper body (i did this by hand after 135,000 miles, no sweat), then install the new pads, "spring/clip", and reinstall the caliper. I've never before had to remove a brake line and unbolt the calpier to replace brakes, and I've done ALOT of brake jobs
35 views
Usually answered in minutes!
×