WHERE IS THE LILL SWITCH LOCATED ON 2003 FORD WINDSTAR SE.3.8

SE or limited will be on the outside of the vehicle. These letters are more for options on the van. Drivetrains remain the same.

A few retaining screws and with the back row of seats removed it just snaps off the inside of the van.

you have to compress the spring to remove the strut

replace the brake lit switch is located at the middle section of brake pedal

Left of steering wheel it is the flasher, four way flasher, headlight flasher and high beams and wiper switch

There is currently no recall on the 2003 Ford Windstar which cites a transmission problem. The 2003 Ford WIndstar was recalled on May 3, 2012 because of a defect in the suspension and front control arm.--------------------------------------------------------------------------------------------
Multi-cardiag M8 CDP

Did you get the battery in upsidedown? just a thought.

Remove "Door Ajar" switch. Clean the switch and use a graphite type lubricant (I recommend "Dry-Slide") to lubricate the actuator on the switch. Reassemble the switch.

The switches are located inside the door panels, attached to the catch mechanism.

1) Remove interior door panel.

2) Using a T-27 Torx driver, remove the 3 bolts holding the catch in the door.
2a) The door ajar switch is the only part on the mechanism with the 2-wire harness.
2b) The switch is located at the rear catch for the sliding door.

3) Using a small flat screwdriver, gently lift the black tab on the catch mechanism and rotate the switch to remove it from the catch assembly.

4) Using a rag, clean the small round actuator and apply a small amount of graphite lubricant to the actuator and work the switch so it moves freely.

5) Reassemble the catch and the door.

Ford cars and such will put a sticker on the hinge or back gate with the numbers on it. It will just be a white sticker with black numbers. A five digit code.

God Bless Greg