Re: I have a 2010 jeep liberty my dr side window stop...
It may have pulled the wire loose from the master panel on the door (with controls for all windows). You should probably take the door panel off and inspect.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The following components are used to control the power windows:
• Driver door module (DDM)
• Passenger front door module (PDM)
• LH rear door module (LRDM)
• RH rear door module (RRDM)
• Driver door switch assembly (DDSA)
• RH front power window switch
• LH rear power window switch
• RH rear power window switch
• LH front power window motor
• RH front power window motor
• LH rear power window motor
• RH rear power window motor
• Class 2 serial data link
• DR MOD PWR C/B 30 Amp circuit breaker
• DRIVER DR MOD 10 Amp fuse -- DDSA and DDM logic, DDM internal driver operation.
• PSGR DR MOD 10 Amp fuse -- PDM logic and internal driver operation.
• REAR DR MOD 15 Amp fuse -- LRDM and RRDM logic and internal driver operation
It is almost for sure you control switch on the door you are using to control these devices. You can get a replacement from an auto parts store like CARQUEST. They are very easy to swap out.
Three things. Fuse, window motor, or bad switch. If the fuse is good, remove the door panel, disconnect the harness to the window motor, and check to see if you have power with a test light/volt meter while pushing the window switch (ignition switch in ON position). If you have power, the motor is bad, if you do not, replace the window switch.
replace the power window switch in the center console.
part cost about $110 dollars. just use a screw driver pop out the center peice and it just unplugs from a wire harness then plug new one in an snap back in..
×