How do I remove the power window switch in a 2007 cruiser?

no separate fuse /relay for switch /motor --possible switch -motor-track problem

Battery Disconnect or Replacement Problems
here you go read this ! Probably the PCM - engine computer just has to reset . When replacing a battery on vehicles with computers an external power supply should be hooked up !

Internal to the switch you probably need a new switch

Check the switch, swop the switch with the one for the drivers window, if that works it you need a new switch, if not its door card off and test out the motor and power feeds

make sure master window switch on the driver side not lock out, if all is good look for bad window relay or blowed fuse.

Land Cruiser 2007 air filter is not located behind the glove box. I removed the glove box and didn't see anything behind it. Does anyone who posts the answer here really changed the cabin air filter for the 2007 land cruiser?

Try this website for resolving car problems by downloading a FREE service manual for your vehicle. This is not an owners manual but a factory mechcanic's manual.

http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

see if you have high beams if you use the flash to pass switch. if you do problem might be in high beam switch

Using a trim stick gently pry out the front power window
switch from the instrument panel switch bezel
and disconnect the switch electrical connector.

Remove HVAC control knobs from control head (just pull out).

Remove one retaining screw to center bezel
inside window switch opening.

Using a trim stick or equivalent, gently pry the
center bezel out of the instrument panel and remove
from vehicle.

Remove mounting fasteners and remove radio
from instrument panel.

REAR - SEDAN ONLY

1. Disconnect and isolate the battery negative cable.
2. Using a trim stick or equivalent, gently pry at the top of the switch.
3. Remove switch and disconnect electrical harness connectors.