SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1
It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.
SOURCE: Shifter cable broke in 1998 chevy suburban
Ok, Disconnect it from the Tranny First. This will make it easier to Fish Through. Connect the New Cable on the Tranny. Follow where the Old one Goes with the New one, Removing the Old one as you go. It will enter the Cab and work it's way up to the Sterring Column. You will Need to remove the Dash Panel to Access the Cable on the Shifter, It just Pulls Loose. You are at the Hardest Part of this at this Point. Let me know if you cannot access the Shifter From this Point. Please Rate My Response! Thanks!
SOURCE: 1998 chevy lumina, shifter on steering column,won't shift
Either the pin that connects rod to tranny is broken off, or there is internal transmission problems.
SOURCE: free parts breakdown diagram transmission 99 chevy
there are a handfull of secrets to rebuild one of these. An ATSG rebuilding manual will give you nearly everything you need. The secrets usually aren't in the books though.
SOURCE: I have a 2004 GMC Envoy the shifter cable came off
Check out this site for the part to fix the transmission end of the cable. Go to the rear end of the transmission on the driver' side (under the car/truck). Make sure to push the transmisssion lever toward the front of the car/truck (park position), the shifter should also be in park. Get the part, install is easy.
http://www.atfbilletparts.com/shifter-cable-repair-kits-by-veh-gmc-vehicles-c-208_219/92-09-gmc-envoy-shifter-cable-repair-pin-p-569
665 views
Usually answered in minutes!
×