Question about 2006 GMC Envoy Xl

Open Question

I have a envoy xl 2006 I can drive it and it runs good no problem and I go somewhere and get in it it won't start it just turns over

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
autodr

autodr

  • 260 Answers

SOURCE: 2006 GMC Envoy XL gas guage

most likely a fuel sending unit problem in the tank. could also be problem in dash but sending unit is first suspect

Posted on Nov 16, 2008

Ad
Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: 2006 Envoy stalling when idels and won't stay running

Clean your Throttle body and pay attention to the Idle Air Control (IAC) valve passageway to try to clean the IAC. A dirty or faulty IAC will cause your engine to stall at idle, the job of the IAC is to open the passage way through the throttle body to regulate the amount of air to enter the engine to keep it from stalling when the Envoy is at idle.

Start with the simple and clean the throttle body and inspect any loose or damaged wire leads to the throttle body. Replace or repair any signs of damage.

Thank you for using Fixya and good luck.

Posted on Apr 13, 2010

choprboz5

  • 197 Answers

SOURCE: how do you replace tailgate struts on a gmc 2006

There should just be metal clips on each end. Use a thin/standard screwdriver and pry out on the clips. They won't come off completey, but just pop out a little ways. Once they do, just pull and wiggle the strut and it should pop off the ball it's snapped on to. To install the new ones, just make sure the new clips are in the "out" position, snap the socket on to the ball and push in on the clip to secure it in place. Hope this helps.

Posted on Jun 11, 2010

wyet_helps

wyet

  • 510 Answers

SOURCE: When is it recommended to give a tune up to a 2006

{: ) The usual recommended tune-up interval is every thirty thousand kilometers.

Posted on Jun 30, 2011

Freddy

  • 1311 Answers

SOURCE: my air blows good in

Could be one of two things, HVAC needs to recalibrate itself or one of the blend doors (or its actuator) is stuck. To accomplish the recalibration, set all HVAC controls and switches to their OFF or CCW positions, pull fuses # 36 and 39 in the rear fuse panel, wait about a minute then reinstall fuses. Do not touch any of the HVAC controls for 2 -3 minutes. If this does not resolve the vent issue, you will need to have the HVAC diagnosed by a technician.

Posted on Jul 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My envoy when you start it an put it in drive it will shut off


Trans needs ajustn at throttlbody. Or may need internal maintenance. Car mite need a scan to get values or codes. May b idling to low or needs tuned up igntion

Sep 25, 2016 | 2006 GMC Envoy Xl

1 Answer

Proper tire size for 2006 envoy


Shane, Base 235 75R16, SLE, SLT, XL SLE, XL SLT P245 65R17,
Denali, XL Denali P245 60R18. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
GMC Envoy Tire Sizes
2006 GMC Envoy Tire Sizes
Tires for my Envoy Denali Recomendations

Jun 27, 2016 | 2006 GMC Envoy

2 Answers

When do i use my gmc envoy 2006 four wheel drive or awd


4x4 when you want it locked in all the time and all when you want it to decide when to kick in

Feb 01, 2011 | 2006 GMC Envoy Xl

1 Answer

Headlights will not turn on manually on my GMC Envoy 2006 model. They were working, I stopped the car and manually turned them off while I sat in the car for a few minutes. I turned off the car, came...


Do your brights work? Check relay # 46 under the hood in the fuse box. Switch it with fuse # 45 (same exact fuse type which runs the electric fan). If you now have lights, change this relay out.

Jan 26, 2011 | 2006 GMC Envoy Xl

2 Answers

2006 envoy vibrates when I put it in drive.


DO U HAVE A CHECK ENGINE LIGHT ON?

Sep 29, 2010 | 2006 GMC Envoy Xl

1 Answer

2006 Envoy stalling when idels and won't stay running


Clean your Throttle body and pay attention to the Idle Air Control (IAC) valve passageway to try to clean the IAC. A dirty or faulty IAC will cause your engine to stall at idle, the job of the IAC is to open the passage way through the throttle body to regulate the amount of air to enter the engine to keep it from stalling when the Envoy is at idle.

Start with the simple and clean the throttle body and inspect any loose or damaged wire leads to the throttle body. Replace or repair any signs of damage.

Thank you for using Fixya and good luck.

Apr 10, 2010 | 2006 GMC Envoy Xl

1 Answer

I have an 06 gmc envoy denali xl and i'm having a rear end saggin


There is a bulletin for this problem.You have to go to the dealership and have the air spring sensor calibrated.Only the dealers can do this calibration.It does not take long to calibrate a vehicle.Unless they find a different problem.Hope this helps.Good luck.

Mar 25, 2010 | 2006 GMC Envoy XL Denali

1 Answer

Electrical malfunctions in 2006 GMC Envoy XL


Check your ignition switch by checking the voltage at the fuses for affected circuts vs. other circuts that are working well...

Jun 21, 2009 | 2006 GMC Envoy Xl

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...