2005 Honda Accord trunk will not stay closed the release lever on the driver side does not seem to have any resistance could it be a broken cable What else should I look for

SOURCE: Water is leaking into the

My 1990 Honda Accord does this too.
When I wash it or when it rains. If I open the trunk/deck lid water flows out of the right rear tail light housing into the trunk.

Solution: get some rubber gasket sealant and apply under the lower gasket around the rear window on each side at the corners. Allow for drying time. Close the trunk and try some water if this doesn't work you will likely have to replace the rear window seal.

Best of luck.

SOURCE: Honda Accord Outside handle broken and Child lock is on.

Remove the panel and disable the child lock or some cars have an option to just bypass the child lock either or

SOURCE: how to open hood when the dash release cable is broken 1996 accor

reach under the front of hood , and pull cable .

SOURCE: trunk/gas tank latch wont work (honda accord)

I have this problem now i got my trunk to lock by going in the trunk and removing the wire from the hook that was keeping it loose. Now i can lock my trunk but i am still looking for a way to get in my gas tank. Help me please if you can.

SOURCE: I have a 2004 Honda Accord EX. Key Fob works trunk but not doors

Programming
When
Key added or replaced. System malfunction.
How
Obtain all keys. A maximum of 3 keys can be programmed. Close all doors and boot/tailgate. Switch ignition ON. Repeat procedure below 3 times: Within 4 seconds: Press key lock or unlock button. Within 4 seconds: Switch ignition OFF. Within 4 seconds: Switch ignition ON. Within 4 seconds: Press key lock or unlock button. System should now lock or unlock vehicle. Within 4 seconds: Press key lock or unlock button. Within 10 seconds: Press lock or unlock button of first key. System should now lock or unlock vehicle. Press lock or unlock button of second key. System should now lock or unlock vehicle. Press lock or unlock button of third key. System should now lock or unlock vehicle. Switch ignition OFF. Remove key. Check operation of all programmed keys.
NOTE: If less than 3 keys are to be programmed, remove ignition key after programming last key.