Question about 2008 Chevrolet Express

Open Question

2008 express 3500 fuel pump no power - 2008 Chevrolet Express

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 12 Answers

SOURCE: 2002 chevy express 3500 turns over but wont start,

CHECK YOUR CRANK SENSOR AND CAM SENSOR.

Posted on Jul 29, 2009

Ad

Superbovine

  • 333 Answers

SOURCE: 1999 Chevy express 454 belt diagram.

454 with ac and a.i.r.
bc0ae5d.gif

Posted on Oct 17, 2009

Testimonial: "You da Man!!!!!!!!!!!!"

roniecon

Ronny Bennett Sr.

  • 6927 Answers

SOURCE: i have a 2008 chevy express cargo van 3500 and i

Have the alternator checked,make sure it is charging correctly.

Posted on Jun 24, 2010

jcameo7270

Jeffrey Cameo

  • 675 Answers

SOURCE: will crank over-fuel pump is

There should be a fuse relay box under the hood with a fuel pump relay in it...have someone turn the key while you touch the relay to see if it is clicking when you turn the key..if not replace relay....if it does click, then it may be possible that the contacts on the relay are defective and the relay will need replacement anyway...there may also be a fuse for the fuel pump either in this box of under the dash...check to see that it is good also.

Posted on Jan 06, 2011

duane_wong

Duane Wong

  • 6826 Answers

SOURCE: how to replace a fuel

Fuel Pump Removal & Installation To Remove:

  1. Disconnect battery negative cable.
  2. Relieve Fuel System Pressure.
  3. Raise and safely support vehicle.
  4. Remove Fuel Tank.
  5. Remove fuel sender assembly by turning cam lock counterclockwise. gm-04-00-954.gif

  6. Remove fuel sender assembly from fuel tank.
To Install:
  1. Using NEW O-ring seal, install fuel pump sender to fuel tank.
  2. Install cam lock assembly and turn clockwise to lock.
  3. Install Fuel Tank.
  4. Cycle the ignition switch ON and OFF to pressurize the fuel system and check for fuel leaks.
prev.gif next.gif

Posted on Jan 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is fuel filter on 2010 chevy express 6.0 liter V8.


2 of them........First Fuel Filter

One fuel filter is in the fuel pump of the Express Chevy 3500, which is used to push fuel or gasoline through the fuel line. The fuel pump is inside the gas tank. This fuel filter is a mesh or screen that prevents large foreign particles for entering the fuel pump. Access to the fuel filter is obtained by removing the fuel tank and then the fuel pump from the fuel tank.

Second Fuel Filter Location

The second fuel filter is within the fuel line itself. After the fuel pumps extracts fuel from the gasoline tank and into the fuel line, fuel flows through the line and through another filter on the driver's side of the Express Chevy 3500 under the front wheel suspension. This fuel filter cleans the small particles that escaped from the fuel tank.

Fuel Filter Types

The year of your Chevy Express 3500 determines what type of fuel filter is installed on the van. The fuel tank filter is always mesh or screen, but the fuel line filter can be of three different types. Two types are snap-on filters, while one type has clip-on ends.

Jan 25, 2018 | Cars & Trucks

1 Answer

2008 chevy express 3500 6.0 fuel pump no power was driving it and it just quit replaced pump still nothing just cranks over


Engine cranking, did you check for spark at the plugs, also, check fuel injector pulse. Any applicable trouble codes?
When you first turn on the key, no crank, can you hear the pump run for a couple seconds?
If only a fuel issue, jump the relay to see if pump will run. Unplug relay, use jumper wire between terminals 30 and 87, the pump should run, don't need to use your key. As you can see, terminal 30 is hot all the time. Also, check that fuse.
Let us know what you find?

express fuel pump relay-whhyjzqjjp5evwrxcrtcuanz-2-0.jpg

Feb 25, 2017 | 2008 Chevrolet Express

1 Answer

Chevy express 3500 no power at fuel pump


Fuse , relay ? What year express ?

Nov 06, 2015 | Cars & Trucks

1 Answer

No power to fuel pump chevy express 3500 van


check your fuse or relay or some cars they have cut out switch for fuel pump as a alarm

May 26, 2012 | 2001 Chevrolet Express

1 Answer

Where is the location of the fuel pressure regulator on a 1999 Chevy Express 3500


it can be in one of 3 places on the pump in the filter or on the fuel injector rail if the filter has 3 lines on it then it is in the filter if it is on the fuel injector rail it is inside the intake but it is more than likely on the pump

Aug 05, 2009 | 1999 Chevrolet Express

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...