Where is the camshaft sensor located at on a 2009 Chev traverse

Check out the videos and images Jose.

https://www.google.com/search?q=2009+Chevrolet+Traverse.+location+of+charcoal+canister

..

Question edited in English 'window'

for every vehicle with power windows ever made?

All question must have 'year make model' as the first three words.

Then I can google
year make model fuse box diagram
and I get this

Chevrolet Traverse (2009-2017) fuses and relays

https://fuse-box.info > chevrolet > chevrolet-traverse-20...
Fuse box diagram (2010-2012, Fuse side) - Fuse box location. It is located underneath the instrument panel, on the passenger side, under the cover.

2009 Chevrolet Traverse Fuse Box Diagrams - Rick's Free ...

https://ricksfreeautorepairadvice.com > ... > Chevrolet
Nov 16, 2018 - 2009 Chevrolet Traverse Fuse Box Diagrams for Underhood and Instrument Panel Fuse Box. The 2009 Chevrolet Traverse has two instrument panel ..

For any specific issues, put and answer up above to Jeff. He is our Pro Technician and a specialist in vehicle electronics.

If you have done everything correct up to this point. This is for camshaft.

there are 2/4 sensors , one on each camshaft

The car needs to be put on a car lift or jacked up and put on safety stands to get to and change the CPS.

did you check your oil level missing 2 liter and more would make that code

alldata.com

before playing with bags, read the whole chapter on bags
in the FSM or alldata.com
they can kill mechanics, and DIY neophotes.
easy. RTM. read the manual first.
ask self would you play with a shot gun and not read the manual first.
sure. not.

I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.

I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.