SOURCE: changing the tail light bulbs on a 2000 mazda 626
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
SOURCE: expansion valve location
raven 1g: Your car doesn't use an expansion valve. It uses a fixed orifice tube which is located in the smaller of the two A/C lines, just before they enter the cabin area of the car.
Just disconnect the line and pull the orifice tube out of the line. Be careful not to break off anything and leave it in the line.
SOURCE: 94 mazda B3000 3.0L cylinder head torque specs
Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds
Use torque sequence below
SOURCE: 2003 mazda 6 3.0 need the main bearing torque specs
I'm sending you the torque specifications for your main bearings and also your head bolts. I also sent you main bearing and cylinder head tightening sequence. I hope this will be useful
Main Bearings Torque specs. 40-43 Ft. Lbs.
Cylinder Head Torque specs. 56-60 Ft. Lbs.
Testimonial: "thank you so much! couldnt find this information anywhere, even called the local mazda dealers!"
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
123 views
Usually answered in minutes!
×