Hazard and Turn Signal Flasher Replacement
Remove the left knee bolster. Refer to
Knee Bolster Replacement in Instrument Panel, Gages and Console.
Remove the left IP endcap. Refer to
Instrument Panel Outer Trim Cover Replacement
Gently pry outward on the rear edge of the IP outer trim cover until the retainers securing the outer trim cover to the IP retainer disengage from the retainer. Slide the IP outer trim cover rearward until the tabs on the front edge of the outer trim cover disengage from the IP retainer.
Remove the knee bolster compartment by pulling past the holding tab (1) and lifting up.
Unsnap the knee bolster by pulling down and rearward to remove from the vehicle
Remove the hazard and turn signal flasher module (1) from the I/P carrier. Disconnect the electrical connector.
>
×