As there are 2 speed sensors located in a transmission, you have to be specific
there is a TSS for turbine speed and a VSS for the output shaft /road speed
post again all the information and the question
But your talking about a turbine wich to my knolage only automatic transmition have.
The sensor I'm looking for is located right below the gear stick.
oh I get it now you call a manual box a standard box
so the speed sensor you are after is the road speed sensor or are you referring to a reversing sensor
go to a transmission shop or a jeep service center and have the problem identified
×
SOURCE: Where is the speed sensor located on a 1999 Jeep
it is located right at the tail shaft of the transfer case where the rear drive shaft comes out.its the only sensor in that area.
SOURCE: what is the fuse box diagram for a 1997 jeep
does this help
I took a stab at which box you needed...
SOURCE: fuse box locations on a 2006 jeep wrangler 4.0
To access the fuse panel the glove box must be removed. It is removed by slipping the glove box strap off the hook and letting the door roll down off its hinges. To reinstall, position the glove box door at an 8 o’clock orientation, engage the hinge hook formations on the lower edge of the glove box door with the hinge pins on the lower edge of the instrument panel. Tilt the upper edge of the glove box door upward toward the instrument panel enough to reattach the glove box strap to the door. Rotate glove box door to closed position. Open and close to insure proper installation.
Also can download the 2006 TJ Wrangler - Owners Manual
Hope helps (remember rated this). Good luck.
SOURCE: 1997 jeep wrangler fuse box diagram. wiper motor
The fuse for the wipers on a 97 wrangler are located behind glove box just unhook strap that holds up glove box and replace.
446 views
Usually answered in minutes!
×