SOURCE: 2000 s10 blazer 4x4
Normal 0 false false false MicrosoftInternetExplorer4
/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;}Hi: If the front diffis fine then it boils down to usually one of three things why it won’tengage. 1 – No power, 2 – relay notworking (located by passenger side) right side or 3 – no vacuum. The 1995 and up Jimmy’s and Blazer’s use thesame system for engaging the front diff. They are all made to “shift on the fly” while driving down the road withnothing to do but press the button on the dash. (Do NOT shift into 4 Low while driving at higher speeds at it can dodamage). If the dash light flashes andyou hear a clicking sound that means you have power to the relay. If the vehicle 4 High lights stops flashingand it goes back into 2 High then the problem is likely that you have no vacuumto the 4 X 4 actuator module which is located below the battery tray. Remove the battery and tray; look for a holeburnt in the vacuum line or actuator module rubber diaphragm. When the activator get vacuum it pulls acable that attaches to the front diff engaging it, when engaged the wires onthe front diff send a signal to the 4 X 4 light on the dash telling you it is engaged). If the battery has ever leaked the acid runsdown onto the actuator causing the problem. If no holes found in the hose or actuator diaphragm I would use batterycables and hook up the battery and start vehicle then check for vacuum byputting my finger on the end of the actuator hose. If there is vacuum then problem in actuatoror cable linkage. If no vacuum I wouldthen trace back the vacuum lines to find where it is off or leaking, NOTE: As the heater control operates on vacuum and some other vehicle systemsdo as well bear this in mind, has your vehicle had heater control problems orbeen running rough, this could explain a lot of potential problems. Attached to the hood on the left side(drivers side) on 1997 and older models is a vacuum (a “ball”) canister, newermodels the canister is located in the left fender by the brake module, makesure the vacuum line is attached there. Please rate this suggestion as I never know if it is worth my timefilling these things out…
230 views
Usually answered in minutes!
×