SOURCE: Keyless Entry and Remote
I have had this problem take you drivers door put your key and un-lock from the out side with key (NO) then open the door push un-lock from the inside button and then set from you remote and it should set if not push un-lock then lock and then do the un-lock with the key. Let me know if that works. what my car did was locked from the inside and I had the problem were it would not work till I un-locked from the out side plus I had to go to radio shack and change the battery from the control.
Hope good happens.
Nikki2913
SOURCE: 2006 Chevy Equinox
Hiya...the factory-installed keyless remote control are installed in most Equinoxes IF SO equipped with this option that year.
However, it's difficult to get "true factory-installed" keyless feature in your Equinox ....but new 2008-2009 Equinoxes built this year now comes with standard keyless remote and yes, new option is remote STARTER feature (that option is identified by a black wire found inside the rear-right quarter window with thin metal line surrounding that interior window to receive signal from remote starter fob)
At least you can find after-market keyless remote control at your local retail store.
SOURCE: program factory remote keyless entry for 2003 Hyundai XG350
This bulletin supersedes TSB# 02-90-001.
DESCRIPTION:
The security system keyless adapter cable (SPX/Kent-Moore P/N 09900-21300) is a special service tool (SST) that is used for programming new keyless entry remote transmitters to the factory security systems. The keyless adapter is used in conjunction with the Hi-Scan Pro (with Hi-Scan SOL Pro Software Version 09-29-03
or newer) and Data Link Connector (DLC) Cable.
SERVICE INFORMATION:
The keyless adapter cable can be used on the following vehicles:
NOTE
SHOP MANUAL
PAGES
2004 MY Elantra
BE-73 - BE-74
2004 MY Santa Fe
BE-43 - BE-44
2004 MY Sonata
BE-40 - BE-41
2004 MY XG350
BE-46 - BE-47
KEYLESS ADAPTER CABLE INSTRUCTIONS:
and press ENTER
.
NOTE
"Release date 29. Sep. 2003" OR LATER
must appear on this screen. To update your SOL card with the latest software go to www.hmaservice.com and refer to TSB 00-00-001.
and press ENTER
.
.
and press ENTER
.
on the Hi-Scan Pro and verify that the remote(s) are functioning properly.
and disconnect the adapter cable from the multi-purpose connector.
SOURCE: Power door locks do not work with keyless remote control
There are two multiplex control units - one on the driver side and one onthe passenger side - which one did you unplug? The one on the driver side is the main "Brain" while the other one is the one that houses the keyless reciever. According to the service manual, any troubleshooting of this system must begin with the one on the driver side. It can get quite involved because Honda does not provide actual troubleshooting (symptom) charts, just descriptions of the electrical connectors and what conditions should be present at each conector pin under what system condition. (each pin has to be tested to determine what is malfunctioning) The system is not capable of outputting fault codes of any kind.
SOURCE: cant find push button keyless entry code
They haven't put the code on the trunk lid for at least 10 years. On the 500/Montego, it's printed on a sticker on the Smart Junction box. This box is behind the fusebox (under the dash on the driver's side, above your left foot), so the sticker is facing the engine. You can use an inspection mirror to see the sticker, but I was able to get my digital camera behind there and take several pictures, and I was able to see the code.
1,064 views
Usually answered in minutes!
×