Installing JVC r530 into a 99 ford explorer - 1999 Ford Explorer

fuel filter is located in drivers side inner frame by drivers door. You will need special tool to remove part#T90T9550B When installing new filter, make sure arrows point forward towards engine for correct fuel flow.

YOU ARE GOING TO NEED A BIG CRESENT WRENCH AND THE TREADS ON THAT ARE REVERSE. DON'T FORGET TO PUT LOCKTITE BACK ON THE THREADS WHEN RE-INSTALLING

How to disconnect anti theft system in may ford explorer 1996 v6

Just gave it to you in your last posting, don't forget to rate both, good luck.

Black-ground, Yellow-battery, Red-switched (ignition), blue-pwr antenna, amplifier remote power, white-left front, grey-right front, green-left rear, purple-right rear. On the speaker wires, the one with the black stripe is ground. Also, I may have got the rear speakers backward, check before permanant mounting.

check fuse first in fuse box if not that then you will probably have to drop the fuel tank and change the fuel sending unit: Note check it first before installing new one because if for some reason thats not it you can just take it back without to much extra effort of having to drop tank again also check the old one by simple hot wiring it.

No tips.. follow the Service Manual (Shop Manual) instructions.

No, there should be no adjustment to the pressure plate.

buy the haynes manual from your local parts retailer for about 20.00 its worth the money.

Retainer clips are used as anchors under the roof line and Tinnerman screws are used with these to fasten it down..accordianman