Mike, 2006 Ford Explorer blower motor resistor location, under dash, passenger side bolted/screwed to plastic duct work/plenum right by the blower motor. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://www.autopartswarehouse.com/shop_years/ford-explorer-blower-motor-resistor-2006.html
2002 2005 Ford Explorer Blower Motor Only Works On High
2004 Expedition Blower Motor Resistor Install tutorial
SOURCE: blower motor 1995 ford explorer
if ur blower only came on the high fan speed i say it was ur blower resistor , but ur blower aint working at all so i would replace the blowerand the resistor cause they eventualy good out with when then the blower problems
SOURCE: locating heater blower motor resistor
the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.
SOURCE: 2006 Ford Explorer XLT the Blower Fan only works on 4 and 3 Sp
Look under the dash on passenger side and just to the left of the blower motor housing you will see the 4WD control module.Remove the 2 screws holding the module and let it hang down and your resistors are behind this.Remove the 2 screws holding the resistors and remove.
Now I am assuming you have manual climate control and not electonic.
SOURCE: 7 wire harness going to blower motor resistor
There is an updated resistor/connector package. Very expensive from GM, try your local NAPA or other parts supplier for a replacement
1,300 views
Usually answered in minutes!
×