It is located on the outside of the transmission case, I assume you mean the vehicle speed sensor and no the turbine shaft speed sensor. If the speed sensor is defective you will have a check engine light on in the dash display. If that is no the case then you may have a failed speedometer.
Testimonial: "Is there a pic that u can send me that points me in the right direction lol"
Thank you can u send diagram of where it's at
Sorry no diagrams for this model are available unless you buy the factory service manual set, about $300
You will need to buy a factory service manual set ($300+) for complete instructions with diagrams.
×
SOURCE: locassion of output speed sensor on 2003 Town and Country
The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.
SOURCE: transmission input speed sensor location
It is located on the front of the transmission. you will see 2 of them one on the left under small transmission lines it is the input then to the right behind the radiator overflow there is the other one. Easiest way to change them is with a 1" deep well socket
SOURCE: Transmission input output speed sensors
The speed sensor is on the tailshaft of the transmission,on the passenger side of the car,it has 3 wires. The output sensors are located on the front of the transmission about mid-way up the housing & only have 2 wires. Note the output sensors are not responsible for vehicle speed. Only the output shaft speed is recorded. They are for finding the correct cvi(clutch volume index) only. If you have a cvi issue,the transmission is toast.
SOURCE: i have a 1996 dodge caravan with the 3 speed
A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR
SOURCE: where are the input and output speed sensor relays
There are no relays in a speed sensor circuit. If you are talking about the relay itself, the output speed sensor is going to be in the extension housing of the transmission, and it probably doesn't have an input speed sensor, since it uses the crankshaft speed sensor as an input speed sensor.
206 views
Usually answered in minutes!
×