At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Fixing a broken glove box on a 2011 Toyota Venza may vary depending on the specific issue with the glove box. However, here are some general steps you can try:
Determine the issue: Inspect the glove box to identify the problem. Common issues with glove boxes include broken hinges, latches, or handles. Once you have identified the issue, you can proceed with the appropriate repair.
Replace the hinges: If the hinges are the problem, you can replace them by removing the old hinges with a screwdriver and installing the new ones.
Fix the latch: If the latch is broken, you may need to replace it. Remove the old latch using a screwdriver and install the new one.
Replace the handle: If the handle is broken, you can remove the old handle and install a new one. This usually requires removing the trim panel to access the handle mechanism.
Check for loose screws: If none of the above steps work, check for any loose screws that may be causing the problem. Tighten any loose screws to see if that fixes the issue.
Seek professional help: If none of these steps work, it may be best to seek the help of a professional mechanic to diagnose and repair the issue.
Remember to be gentle with the glove box during the repair process to avoid causing further damage.
I have an 03 Aztek and my latch just broke the trick to getting it open is a screwdriver or a little hook of some sort... Pull the handle back and look up under u will see a metal bar on the right side. get a grip of that and pull/pry a little bit and it will open. Once open there are 2 philips head screws holding it in and that's it
If it is unlocked, the the pin attached to the handle could be broken. There is a small "U" shaped metal piece that is part of the mechanism inside the handle. You have to first pull up the handle as if to open it and slide your finger in towards the top then once you feel it push it down, your finger is replacing the broken pin. This should open it. Hope this helps.
This happened in my '01 galant as well. If you take a peek under where the handle used to be, there's a little square nook with a spring and a little plastic tab. take a key and stick it right above the tab and press down, and the glove compartment should just pop right open. If it doesn't work, then it's probably just locked. Just unlock the door and try it again.
use a flat head screw driver and there is a pin that slides sideways. slide it towards the driver side while u pull. my car did that and i got it open. :)
If the glove box is anything like mine it is a modular piece assembled with screws.... let them break the handle.. get a replacement first from a junk dealer and have the broken part swapped out. Its like a seat belt catch in my 97 deville. The glove box in mine flopped open and the catch had broken and fell down the door of the glovebox itself. The whole door is assembled with philips screws and should be easily removed and a new latch put in.. whoever does it should not cost more than 50.00 in labor MAYBE unless you have a friend that would do it for a beer. I saw a complete glove box on ebay for 40.00 shipping ontop of that .. i saw the latch for 20.00 +shipping.
×