Kase skid steer starts bit wont ingage any of the controls, info board keeps flashin seatbelt light and i cant unlock or take off parking brake????

SOURCE: 1998 grand am parking brake light wont go of. cant shift from par

Sounds to me if it has rear disc brakes you have 1 or 2 bad calipers

SOURCE: Dash board parking brake and ABS lights stay

you have an abs fault. have your abs system scanned for codes.

your base brakes will continue to function normally

SOURCE: Parking brake light keeps blinking, 4 blink code?

make sure emergency brake pedal is pulled all the way up

Raygin

• 322 Answers
• Posted on Jun 09, 2010

SOURCE: Parking Brake Fault

This is a common fault often caused by low battery voltage, before you start taking expensive actions with the park brake modules etc get your battery checked for 100% efficiency.
Hope this helps, good luck.

chargerhp

• 815 Answers
• Posted on Dec 21, 2011

SOURCE: My 2005 Pacifica will not

SHIFTER LOCKED IN PLACE

1. Remove the instrument panel cover below the steering column, then remove the steering column shrouds to gain access to the brake transmission shift interlock (BTSI) solenoid. The solenoid is part of the interlock cable assembly.
2. Disconnect the wire connector from the rear of the BTSI solenoid.
3. Insert the ignition key and turn it to the ON position.
4. With the brakes applied, try moving the shifter out of the PARK position.

• If the lever now moves freely in and out of PARK, perform the Circuit Test below.
• If the shift lever still does not move from the PARK position, remove the BTSI solenoid from the shift lever assembly. If the shift lever now moves freely in and out of the park position, the BTSI solenoid is faulty and the interlock cable must be replaced. If the shift lever still does not move from the park position, the problem is in the shift lever assembly or the ignition interlock cassette