Every car brand and model has its procedure to stop the flashing light and alarm sounding.
But still the common procedure is Make sure boot and bonnet are closed properly.
It can also be a switch, but check your alarm by locking yourself inside the car, and then press the close button on the key 2 times repeatedly until the lock control on the door doesn't make anything. Then open the door by pushing the lever or open the hood . If the horn sounds and the lights blink your alarm is ok , if only the lights blink you should take it to dealer. You can stop the hazard lights and horn sound by pressing the unlock button on the key.
SOURCE: hazard and turn signal
Under the dash is a flasher unit. Replace it and everything should start working again. The flasher unit is very inexpensive and available at most parts stores.
SOURCE: my hazard lights and turn signals stopped flashing
i bet you have a bad multi function switch or turn sig switch. good luck
SOURCE: 2001 Dodge Neon, Flashing Hazard Lights
that is a good one it has come in twice there is a lose wire in the steering columb that will touch when it gets wiggled. make sure to check there first. it has also been the flasher fuse so check there too
SOURCE: turn signal and hazard lights failure bulbs ok
That is a different filement in the bulb for the alarm. Try replacing all the outside bulbs.
SOURCE: Audi A4 2003 Alarm Problem
There is a few things to do check the door switches that control dome lights, check wire down by the skid plate when you get oil changed there is a sensor for the starter there if it is stolen the alarm will go off or just take a BAT and BEAT the living **** out of your horn and call it good like I am going to. I hope this helped or will help I recommend an aluminum bat vrs. wood
1,041 views
Usually answered in minutes!
×