P1589- Acceleration sensor learning.
Zero Point Calibration Using Jumper wire
The following manual procedure may be used in the cases where a Diagnostic Tester is
not available.
CAUTION:
While performing the Zero Point Calibration, do NOT tilt, move, or shake the vehicle.
The vehicle must remain in a stationary condition throughout the entire process.
Be sure to perform the procedure on a level surface with an inclination of less than 1%.
1. If the vehicle is equipped with A/T, ensure that the shift lever is in the "P" range and
the parking brake is applied. If the vehicle is equipped with a M/T, ensure that the
parking brake is applied.
2. Turn the ignition switch ON.
3. Using the SST, repeat a cycle of short and open between terminals Ts and CG of
DLC3 4 times or more within 8 seconds (refer to the specific vehicle EWD for TS and
CG pin location in the DLC3).
4. Verify that the VSC indicator light is lit indicating the recorded zero point is erased.
5. Turn the ignition switch OFF.
6. Be sure the terminals Ts and CG of DLC3 are disconnected.
7. Turn the ignition switch ON.
8. Check that the VSC warning light goes off about 15 seconds after the ignition switch
is turned ON.
9. After ensuring that the VSC warning light remains OFF for 2 seconds, turn the ignition
switch OFF.
10. Connect terminals Ts and CG of DLC3 using the SST.
11. Turn the ignition switch ON.
12. After turning the ignition switch ON, check that the VSC warning light is lit for about
4 seconds and then starts quick blinking at 0.13 second intervals.
13. After ensuring the blinking of the VSC warning light for 2 seconds, turn the ignition
switch OFF.
14. Remove the SST from terminals Ts and CG of DLC3.
15. Drive the vehicle for at least 5 minutes to confirm Zero Point Calibration is complete.
IF FAILED REPLACE THE BRAKE ACTUATOR - SKID CONTROL ECU.
SOURCE: temperature light of vitz toyota
Check your coolant level first then start having sensors checked. Could be a bad sensor or wiring issue.
SOURCE: pls help me in details as i dont have the user manual for toyota vitz
speedo can be a cable to the gearbox or the dash itself?
a/c may need a re gas
SOURCE: How to fix code p1589
START BY REPLACING THE THROTTLE POSITION SENSOR, I CANT GUARANTEE THAT IT WILL WORK, BUT IT IS A GOOD PLACE TO START.
IT WOULD ALSO HELP TO KNOW THE MAKE OF THE AUTO.
4,869 views
Usually answered in minutes!
×