2008 Dodge Grand Caravan Logo

Related Topics:

Rodney Rogers Posted on Jan 16, 2016

How to replace the abs module

Need to replace the abs module on my 2008 dodge grand caravan do I have to put the van on jack stands

5 Related Answers

Anonymous

  • 512 Answers
  • Posted on Nov 13, 2008

SOURCE: PCV Valve on 05 Dodge Grand Caravan

3.3 and 3.8 engine pcv valves are it the rear head valve cover. they are a pain to remove

Ad

Anonymous

  • 1902 Answers
  • Posted on Apr 15, 2009

SOURCE: antilock brake system in 1992 dodge grand caravan

Recall is a recall, doesnt matter who the owner is. CAll the dealership tell them that you have this year and model and make and they will ask for the VIN and give it to them. If it comes up in the system that it falls under the recall, then have it towed to the shop and tell them that it is a recall repair and make sure it is noted on the paper work

Anonymous

  • 137 Answers
  • Posted on Jul 23, 2009

SOURCE: 2007 Dodge Caravan ABS light stays on after

Common issue when a wheel sensor gets faulty.On every wheel there is a sensor which informs the ABS system about wheel speed.If any of them is broken then the ABS system locks up and you get the warning light.In this case your brakes are working just as fine but you dont have ABS so wheels can block when you push the brake hard enough.Trouble code reader can tell you which one is faulty.

Anonymous

  • 5081 Answers
  • Posted on Nov 23, 2009

SOURCE: Heater blower motor replacement -1997 Dodge Grand Caravan

Remove the cover plate on the passenger side of the heater box, 3-4 screws.
Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull it down from its position. Get an aftermarket motor and installed it in the original housing with the original squirrel cage.
Installation is the reverse of removal.

Anonymous

  • 4 Answers
  • Posted on Sep 06, 2010

SOURCE: When I put my key in the ignition of my 2008 dodge

Newer Dodge Vehicles do not have an ignition for a "metal" key. They use the Electronic Key called a FOB with a built in or integrated metal key that is only used to unlock the door. The FOB inserts into a WIN module (Wireless Ignition Module) instead of the normal igition. Reprogramming the vehicle usually does the trick however there has been significant problems with the WIN module and the dealer may have to replace it. The 2010's have a recall on some models. The manual states the keys cannot be reprogrammed. The first and easiest solution might be to try replacing the battery in the FOB (aka key),

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Where is the anti-lock sensor module

The ABS control module is located on the driver side in the engine compartment. C2200 code would be an internal fault of the ABS control module.
0helpful
1answer

How do you work the VES on a 2008 grand caravan

It is the ribbon cable in the first row monitor need to pull it apart and replace dodge does not stand behind this problem and won't issue a recall even though it is very common this van is built to last as long as warranty and that's it it's what we in the biz call a throw away car buy it drive warranty away and dump it sorry guys hell I own one not my best decision
2helpful
1answer

Remove rear evaporator core 2008 dodge grand caravan

it is inside the right rear corner of the van with line connections under the van you will need to remove the plastic cover inside the rear corner
0helpful
1answer

Rapid clicking noise from driverside dash even after removing key dodge caravan

My 2008 dodge grand caravan does the same thing. I can unlock my doors and the clicking from the dashboard will start. I turn van on . (Engine is running) and nose gets louder and faster. It's almost like the shift lock is spazzing.out. I put.my hand on dash next to gear shifter and I can feel vibration from where noise is coming from. Also when I turn van off and get out if van. The noise of clicking keeps going. But than stops afterwhile..does.any dodge mechanic know what this is.?
0helpful
1answer

2008 Dodge Caravan- my battery died and I replaced when I started my van I had a few light on my panel. After I moved my van all went out exept the check engine light any idea why?

it may be computer or you need check engine oil electronics can be tricky sometimes a good run will help or you need a factory code
0helpful
1answer

How do you get the back three spark plugs out to replace on a dodge caravan yr 2000

My information says to remove the windshield wiper/motor module assembly from the vehicle for access to the spark plugs on the firewall side. When We owned our '99 Grand Voyager, I put the front up on jack stands and got the back three plugs from underneath.
0helpful
1answer

How to get drum pads off a 2000 dodge caravan

The pad drums of your 2000 Dodge Grand Caravan can wear with use. Heat buildup in the brakes can glaze, warp or crack the drum. If that happens, replacement of the drum is the only way to fix it. In most cases, you can remove the rear drums, replace them with a new set and leave the existing shoes on the van. Take a minute and inspect the brake shoes thoroughly while you have the drums off the van.


  1. Loosen the lug nuts on the rear of your 2000 Dodge Grand Caravan with a lug wrench. Do not take them off the wheel studs.
  2. Raise the rear of the van with a jack and support it on a set of jack stands. Place the stands under the rear suspension, making sure they are secure. Remove the lug nuts from the wheel studs and pull off the rear wheels.
  3. Check the rear drum where the wheel studs come through for retaining clips. These are used during the manufacturing process; and if they are still on your van, they need to be removed. Pry the clip off the wheel stud with a flat head screwdriver and discard them. Most vehicles will have two clips on each brake drum.
  4. Grasp the brake drum on the outer edges and pull it straight off the wheel studs and brake pads. Discard the old drum and slide the new drum into place, aligning the holes in the drum with the wheel studs. Push the drum in until it seats completely. Repeat the process on the opposite side of the van.
  5. Position the wheel back on the wheel studs and install the lug nuts by hand. Raise the back of the van with a jack and remove the jack stands from under the suspension. Lower the van to the ground and tighten the lug nuts with a lug wrench.
11helpful
3answers

2008 Grand Caravan won't start. The lock/unlock

I am having this same issue with my 2008 Dodge Grand Caravan , I had it towed to the local Dodge Dealership. They just told me that it is the Wireless Control Module and it is going to cost $461.00 to replace it.
0helpful
1answer

Want to delete auto lock door system to stop doors from locking every time i put van in gear

All vehicles are equipt with that option as of now. I would leave that one alone for saftey reasons such as car jacking for one
4helpful
2answers

How do I change the rear 3 spark plugs on a '94 Grand Caravan?

Yes, these are tough to get at from the top. Put the front on jack stands or ramps, and you can reach them a little easier from the bottom. You just need to reach up where the exhaust pipe comes down, and you can even see what you're doing this way.

Not finding what you are looking for?

279 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...