At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the immobilizer light is coming on and the engine is cranking but not starting, it's likely that the immobilizer system is not recognizing the key and is preventing the engine from starting. Here are a few things you can try:
Check the battery in the key fob: Make sure the battery in the key fob is not dead. A low battery can cause the immobilizer system to not recognize the key.
Try a different key: If all three keys are not working, it's possible that the immobilizer system itself is faulty. Try a different key to see if the problem persists.
Check the immobilizer system: If the problem persists with all keys, it's possible that there is a problem with the immobilizer system itself. This could be a faulty immobilizer module, antenna coil, or wiring. You may need to have the system diagnosed and repaired by a professional mechanic.
Check the fuel system: If the immobilizer system is not recognizing the key, the fuel system may not be primed correctly. Check the fuel pressure and ensure that the fuel pump is working properly.
It's important to have this issue diagnosed and repaired as soon as possible to avoid further damage to the engine or electrical system. If you're unsure about driving the vehicle, have it towed to a repair shop.
door lock assembly
indicates that the lock and the handle sections are not properly aligned
leave the screws slightly loose and operate it as you tighten the screws
My personal suggestion would be to go for these repair catalogs. I know this website www.reliable-store.com that i used to get manuals from, and they have all models online.
I also
brought for my 1989 BMW, such old model, they had it and it was very good manual. Go ahead, I bet.
Turn the ignition key to the accessories position.
Within 5 seconds of turning the key, hit the rear demister button (center console) three times in succession.
The door locks will cycle once to indicate the special mode has been entered.
Press any button on the remote you wish to program.
The doors will cycle to indicate a new remote has been programmed.
Continue steps 6 and 7 for all remotes (including existing ones) you intend to use on the vehicle.
When you've programmed all the remotes, turn the ignition key off. The doors should cycle again to indicate the programming session has been completed.
But you can try the following , does not always work :
the instructions prior to performing the OilReset:
1) Turn the ignition switch to on (do not start the engine).
2) Select maintenance indicator within 4 seconds by double tapping the instrument cluster button (to the left of the odomoter) and hold it down on the second press.
3) Continue to hold button and turn the ignition off.
4) Turn the ignition switch on (do not start the engine) and continue to hold the button for 10 seconds. The wrench symbol should begin to flash and eventually go out.
5) Turn the ignition off and then start the engine to verify the indicator has been reset.
Look in your owners manual and go to the part that explains the different symbols on your dash. Look for that service reminder and it should tell you what page to go to to learn more about that. Somewhere there should be some wording to the effect that "When you have your car serviced by a certified Toyota dealer they will reset it for you. In the event that someone other does your maintenance then this is the procedure to reset......."
×