Why won't it start?

hi Roy.
The starter won't crank. If nothing happens when you turn the ignition key to the "Start" position, it means that the starter motor doesn't turn over the engine. Most commonly this could be caused by a dead battery; here is How to check the battery. ... The ignition switch could be bad - it's a common problem.13 Aug 2013

Why a car won't start - troubleshooting tips - Samarins.com

How do you fix a car that won t start?
When your car responds with silence or clicking:

1. Turn on the car lights. ...
2. Tighten and clean the battery connections and try again. ...
3. Jump start the car.
4. If this works, immediately have the battery tested, especially if it's old. ...
5. Things could still be worse - such as a bad starter or alternator.

Car Won't Start? Here's What You Should Do ' GEICO

https://www.geico.com/more/driving/auto/auto-care/what-to-do-if-your-car-wont-start/ Search for: How do you fix a car that won t start?

hi there.
this youtube video might help you out.
NISSAN MICAR k12 WON START OR TURN OVER RANDOM PROBLEMS WITH IGNITION
or this google link.
Nissan micra k12 won start Google Search

sounds like the ignition control switch has gone bad. all light will come one but if you turn to start and nothing happen but works with remote starter then the first thing to get checked is the ignition control switch.

If by lights, you mean the dash lights come on, then ignition switch must be getting power. If dash is not working with key on, check the 30 amp fuse link which powers the ignition switch.
If switch is good and starter is good, the start wire from switch goes to, if automatic, to inhibitor relay (the park/neutral function) and then to starter. There is also an inhibitor switch on the shifter or on the transaxle that turns on the inhibitor relay when key is on and shifter in park or neutral. The inhibitor switch is powered by a 10 amp fuse D.
If you have a manual transmission, the start wire from ignition switch goes to the clutch interlock relay and then to the starter. This relay is turned on by the clutch interlock switch on the clutch pedal.
You can check for power on either relay, the inhibitor relay or the clutch interlock relay, with a test light. Pull the relay out, have the key held in start position. Now both relays would have power showing on two terminals where the relay plugs in. If inhibitor relay only has power on one terminal or no power at all, either ignition switch is not sending power or fuse D is out or the inhibitor switch is not working right. If clutch interlock switch does not have power on two terminals either the ignition switch is not sending power or the clutch interlock switch is bad.
If the relay checks are good, check for power on the small wire to starter with key held in start. If you have power there, the starter solenoid must be out.

The first thing I would check is the starter motor fuse and relay, but the lights staying on is weird. Perhaps the ignition key switch is defective. That could be caused by many things including wear and tear / moisture / insects, especially if the car is old and you are living in a warm and humid climate.

Is the security light on or blinking?If not then do you have power to the starter.You can check this with a test light.You should have power when you turn the key to start.The test light should light up.Should be the small wire.I believe it is purple in color.If the security light is on then you will have to get the codes to see what is causing the no start.Hope this helps.Good luck.

if nothing happens when you turn the key the problem is most likely the ignition switch and housing(had mine replaced 3 times already. firstr time at 12,000 miles) what you can try is hit key with rubber mallet while trying to turn but this would only be to get it started so you can drive to a chevy dealer(dont waste your time at any old repair shop for this). Hope this helps.

If the security light keeps flashing,you might as well do a reset.
Be sure to turn off all the accesories including the radio before you start the process.
Insert the key to the ignition switch and turn the key to ON position without starting the car.
leave it ON until the flashing light (security) stops.It will take approximately 15 to 20 minutes.
As soon the flashing stop,turn the key to OFF
position and start the cart.
Hope this help.

It could be a bad ignition switch, do you have instrument panel warning lights when you try to start it?

could be a bad igntion switch. Or a connection from the igntion switch.