No. The control panel has an internal module incorporated within it. You can try disconnecting the battery to see if it comes back on line. If not, you may be dealership bound
Chevy Traverse Forum: A/C won't change positions and passenger won ...
www.traverseforum.com > Chevy Traverse > Tech Section > HVAC
Apr 6, 2013 - 20 posts - 11 authors
I have a 2009 Traverse LT (w/ 42k miles... ) and we just ... Turn the car on, but DONOT TOUCH the HVAC controls. The AC will come on and ...
Dual Climate Control not working properly ...
11 posts
Sep 5, 2014
Front power outlet (cigarette lighter plug ...
8 posts
Mar 1, 2013
2009 Traverse Heat Selector Switch Not Working
18 posts
Nov 13, 2012
Air conditioning problem with 2009 Traverse
20 posts
Jun 30, 2011
More results from www.traverseforum.com
Compressor : Chevrolet Equinox Common Heating & Air ...
repairpal.com > Problems > Chevrolet > Equinox
GM Recalls 2010 Chevy Equinox and GMC Terrainwww.autoevolution.com > News > RecallsDec 29, 2009 - "The software in the center instrument panel can cause the heating, air conditioning defrost, ... I have a 2007 Equinox, just had the fuel injectors cleaned out..... On 1 February 2011 at 23:32 UTC, al (gonzo) said: .... 60,000 miles I wonder if that will be covered under this recall? does say ac may stop working.Ac Problem: I Have a 2007 Equinox. the Air Conditioner Will ...www.2carpros.com/questions/2007-chevrolet-equinox-ac-problem
SOURCE: Relay center location
Finally located the AC primary small relay in the relay center under the right dashboard site. The relay had burned winding and only the resistor connected parallel to the coil was showing some resistance otherwise it wasn't engaging when I applied power to it. The Buick is actually 1990.
SOURCE: AIR CONDITIONING
Well my a/c spopped working to,was told it was themegentic clutch switch that work the compressor,might have to replace a/c compressor
SOURCE: fuse for locks constantly blows
Try replacing the relay. Clean the socket of the relay and fuse
SOURCE: 1991 Sierra GMC AC control problem
The follwing is a cut and paste from a service bulletin:
Bulletin No.: 461202
Date: May, 1994
SUBJECT:
A/C CONTROL HEAD FLASHES OR ERRATIC OPERATION OF A/C CONTROLS (POLISH
TERMINALS)
MODELS:
1988-94 CHEVROLET AND GMC TRUCK C/K MODELS
1990-94 CHEVROLET AND GMC TRUCK TOPKICK/KODIAK MODELS WITH C60 OR C69 AIR
CONDITIONING
CONDITION:
A/C Control Head flashes, performs erratically or malfunctions.
CAUSE:
Light surface corrosion on the Control Head terminals.
CORRECTION:
Remove the A/C Control Head and while holding the unit with the terminal
cavity down (toward the floor) so no particles will fall inside on the
circuit boards, polish the terminals on both sides of the cavity with a lead
pencil pink eraser. Do not use an ink eraser or other abrasive such as a
small wire brush or sandpaper, etc. Doing so will remove the terminal
coating and degrade the contact surface.
Performing this procedure, in many cases, will make replacing the Control
Head unnecessary. Using this procedure in conjunction with the A/C circuit
diagnosis found in the Electrical Diagnosis Manual and especially before
replacing a Control Head for any reason is recommended.
After polishing the Control Head terminals, but before reconnecting, check
for proper terminal contact as described in the applicable electrical
diagnosis manual. If contact is good, apply dielectric grease (P/N 12345579)
to the harness connector terminals. Please do not apply grease to the
Control Head.
2,368 views
Usually answered in minutes!
×