SOURCE: wheel bearing change for 98 malibu
you have too change the whole assembly
pull the wheel pull the callipilar pull the callipliar mount pull the rotor pull the half shaft nut then take the three bolts out of the hub assembly and pull it less than hour job !!!!
SOURCE: chey aveo front hub bearing what is this?
yes front wheen drives have hub bearings. Most of them need the hubs to be pressed apart to replace them. the hub bearing supports the end of the CV drive shaft closest to the wheel. hope that helps.
SOURCE: 2004 Chevrolet Aveo Brake lights not working
A couple of days ago my brake lights on my 2004 Chevy Aveo wouldn't work, so I attempted to remove the lamp covers to check the bulbs. Also, before this my shifter would get stuck in park and could only be released by pressing the unlock gadget next to the shifter. Back to the brakes...Well, you open the trunk and remove the two screws just like the manual said, but it was very hard to pull off. There's 2 prongs holding the other half of the light on. The lamp will come loose by prying it (very hard). You think the cover will break, but it'll come loose. The bulbs were all OK.
After much frustration and internet info, the STOP LAMP SWITCH, GM#96436331 ($9.30 at Chevy dealer), which is located under the dash and has contact with the brake pedal, was defective. Once replaced, both my brake lights AND SHIFTING problems were cured. So if the brake lights suddenly don't work or you have problems getting the vehicle out of park, check the switch by pushing the prong (end that has contact with brake) of the switch in and out. If it doesn't retract smoothly...that's the PROBLEM. Good Luck.
SOURCE: I'm looking for the procedure to install a front
Hub bolts are around 65-70 foot pounds, axle nut is about 120-130 ft pounds. These are not super-critical. Many at shops are installed using air guns and work just fine. Your main objective is to not have them come loose. If axle nut has a cotter pin, never back off on nut to install. always tighten to get holes for pin aligned.
SOURCE: 2004 Aveo roaring noise from front and rear wheels that
wheel bearing or cv joint . remove brake caleber remove spindel nut outer bearing comes out easy inter bearing is is a little harder
249 views
Usually answered in minutes!
×