SOURCE: saturn crankshaft sensor
Right above the started. It can be removed from under the car withour taking the starer out. 5 minute job, one bolt
SOURCE: saturn ion blower motor
lower settings as far as speeds for your blower motor go through a resister block to reduce the voltage your blower motor receives to make it turn slower. If it turns slow on high you would have to check the voltage at the blower motor, should be the same voltage that would be at the battery. There could also be material in the blower motor fan like things a mouse could have put there. Causes the fan to spin slower and also blocks the fins from pushing air. Any strange noises would be heard unless you have had the prob since you owned it and could not detect any changes. It could be even full of stuff and still
be in balance. but it could be a few other things.
SOURCE: where is 2003 saturn ion thermostat?
FACEING the ENGINE It is At TOP RIGHT SIDE Close to Master Cylinder takes About 1 hour to Replace Have Fun its a EASY One
Please Dont forget to RATE ME Thank You
Remove the feed pipe
Installation Procedure
Install the thermostat and retaining sleeve with the dimple placed into the housing slotImportant: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump.
SOURCE: Oxygen sensor location on a 2003 Saturn Ion-1
One is front of the cat, and one after the cat of the exhaust.
The OBD Scanner should tell you which bank is producing the error.
Bank one is the front one.
Thanks for using FixYa - a FixYa rating is appreciated!!
SOURCE: how do you change the downstream oxygen sensor in
Downstream O2 sensor is the O2 sensor after the Catalytic converter. Jack the car off the ground so you can get under it, disconnect the wire leads and with a close end wrench. Snake the wire leads through and wrench and place the wrench one the O2 sensor and with a hammer, tap the wrench to break lose the O2 sensor from the exhaust pipe. Once the O2 sensor has loosen up, just remove and install the new O2 sensor. Reconnect the wire leads, start the car and listen for any exhaust leaks. Once no leak has been determined, Place car back on the ground and go for test drive. Check engine light should go off after three start up and car has reached it's operating temperature and DTC codes will be erased after 100start cycle. Good luck and be safe.
120 views
Usually answered in minutes!
×